Kyocera - Основной каталог 2010-2011 ENG
для заказа - kyocera@kyocera-tools.ru
Slot width (edge width) adjustment of MSTC slot mills
Slot width (edge width) measurement
No.6 No.5 1) Please check slot mill egde location number.
(The edge location number is marked on the slot mill body.)
No.7 No.4
2) Set up the slot mill on length measuring equipment such as tool
No.8 presetters.
No.3 3) Place the point A of the slot mill body near the position No.1 to “0
(zero)” of the length measuring equipment.
4) Move the length measuring equipment to the insert corner part and
measure the step (Y1) between the point A and the insert No.1.
5) Likewise, measure the step between the slot mill body and the
insert, and you will obtain the slot width (edge width).
No.1 No.2 Slot width
(edge width)
Body Blade width
In the case of changing the slot width (edge width) 1) Set up the slot mill on length measuring equipment such as tool
presetters.
Wedge Lock Screw Wedge
2) Insert a 3mm Hexagon wrench(TH-3L) into the wedge screw.
3) Turn TH-3L counterclockwise to loosen the Wedge.
4) Turn TH-3L clockwise by the torque of 1 Nm to tighten the
wedge lightly and make the wedge to contact the cartridge and
the slot mill body. In doing so, some resistance occurs against
the cartridge.
Loosen Tighten
TH-3L
(Hexagon wrench with 3mm width)
Hexagon Wrench Cartridge 5) Insert a Hexagon wrench (LW-2.5 or LW-3) into the Cam Pin on M
the back of the cartridge.
6) Turn the wrench and adjust the position of the Cartridge.
7) To secure the adjustment, back the Cam Pin off and make sure
that it does not touch the groove surface of the back of the Car-
tridge.
8) Remove the Hexagon wrench from the Cam Pin.
Milling
Cam Pin 9) Insert TH-3L into the Wedge Screw.
Wedge Lock Screw 10) Tighten the Wedge Screw by the torque of 5-6Nm.
(Use a torque wrench to get the correct torque.)
11) Make sure there is no gap between the Cartridge and the Slot
Mill body.
Make sure there is no gap.
Tightening Torque
TH-3L
kyocera@kyocera-tools.ru M117
www.kyocera-tools.ru