Kyocera - Основной каталог 2011-2012 ENG
для заказа - kyocera@kyocera-tools.ru
2 When using both Main and Sub spindles Main spindle Sub spindle
In this case, when the cutting edge runs beyond the center line, the insert will
contact the workpiece, since the workpiece does not fall off.
Therefore the programmed distance beyond the center must be considered.
e.g. When the cutting edge is programmed to run 1mm beyond the center.
Workpiece maximum, D2 (Fig.4) = [Dmax - 1mm2] (mm)
(The clearance between the insert and the workpiece is 0.2mm)
Fig.3 Fig.4
When the edge is at the center) When the edge is 1mm beyond the center)
When using TKF-AS type
The KTKF holder can be used as a multi-functional
tool for non-ferrous metals and non metals when
combined with a TKF-AS insert (See Fig.5).
Fig.5 Example of the pass of KTKF toolholder + TKF-AS insert H
Longitudinal Turning / Grooving 1-Edge insert Classification of usage Nonferrous Alloy with interruption
N
: Continuous-Low Interruption / 1st Choice Nonferrous Alloy without interruption
No. of Corners
Edge Preparation : Continuous-Low Interruption / 2nd Choice Titanium Alloy with interruption KPD001
: Continuous / 1st Choice Applicable Toolholder
PCD all models Sharp Edge S Cut-off
: Continuous / 2nd Choice Titanium Alloy without interruption
Dimension (mm) Angle PCD
(°)
Insert Description D
max
Handed Insert shows R-hand. W r T H A d S
rd RL
r TKF12 200-AS 2.0 10 5.0
250-AS
±0.03 3 8.7 7.7
W HT 2.5 10 +0 5.5
-0.05 5 0°
0.1 1
B TKF16 250-AS 2.5 16 4 9.5 8.5 6.5
TKF12
Traversing / Grooving 150-NB H8
200-NB
E 250-NB 1.5 7 2.0
250-NB4.5
S )5 2.0 8 +0 3.0
-0.05 5 0° 1
8 %NBY 0.1 3 8.7 -
3.0
S 2.5 8
Grooving 2.5 10 4.5
(Traversing is possible
Dmax
Lead angle shows the angle when installed in toolholder.
Please use PCD Insert for traverse machining.
KTKF Toolholder
Note The cutting edge of the TKF..-AS will be 1 mm lower h1
than the center line when attached to the KTKF
toolholder (See Fig.6). Adjust the height by making Dmax Fig.6When a TKF-AS insert is attached H1 H1
NC lathe parameter settings or inserting a plate. ( The cutting edge is 1 mm lower than
If the 1 mm adjustment is not possible, the center line.)
use the TKF. . -NB (See Fig.7).
KTKF Toolholder
h
Std. Item Fig.7When a TKF-NB insert is attached
CBN & PCD Tools are sold in 1 piece
для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru boxes. H9