Kyocera - Основной каталог 2010-2011 ENG
для заказа - kyocera@kyocera-tools.ru
Turning Indexable Inserts
55°Diamond • Positive with Hole (mm)
Description A T d
DC_0702_ 6.35 2.38 2.8 7
DC_11T3_ 9.525 3.97 4.4 7
B P Free-cutting steel
Classication of usage
Positive Ar
Insert d Carbon Steel and Alloy Steel : Interruption / 1st Choice
M Stainless Steel
$ : Interruption / 2nd Choice
% Gray Cast Iron
3 K : Light Interruption / 1st Choice
4 Nodular Cast Iron
:Light Interruption / 2nd Choice
N
Non-ferrous Metals :Continuous / 1st Choice
T S Heat-resistant alloy : Continuous / 2nd Choice
Description
55 Titanium Alloy (In case hardness is under 45HRC)
Insert
H Hard Materials
PVD
Coated Carbide
Dim. TN6010CermetPVD
(mm) TN6020Cermet
TN60
PV7005
PV7010
PV7020
CA5505
CA5515
CA5525
CA5535
CA6515
CA6525
CA4010
CA4115
CA4120
CA4505
CA4515
PR930
PR1005
PR1025
PR1125
KW10 Carbide
Ref. Page for
Toolholder
CD Coated Carbide
r Applicable
Chipbreaker Range
5 DCGT 070202FN-Z 0.2Medium
7 070204FN-Z 0.4
DCGT 11T302FN-Z 0.2
8 11T304FN-Z 0.4
Sharp Edge 11T308FN-Z 0.8
Insert (Turning) Low Carbon Steel Low Carbon Steel DCMT 070204XP 0.4 Refer to the table below(mm) (Low Carbon Steel)
4 (Sticky Material)
ap
DCMT 11T302XP 0.2 3 XQ (11)
11T304XP 0.4
Finishing 11T308XP 0.8 XP (07)
2
1
DCMT 11T304XQ 0.4 XP (11) 0.4
11T308XQ 0.8 0.1 0.2 0.3
Finishing-Medium f (mm/rev)
DCMT 070202MQ 0.2 (mm) (Stainless Steel)
070204MQ 0.4 2
Stainless Steel
ap
1
MQ
DCMT 11T302MQ 0.2 0.1 0.2 0.3 0.4
11T304MQ 0.4 f (mm/rev)
Finishing-Medium
Insert whose corner R(r) dimension expressed with less than sign (e.g. <0.05, <0.1, <0.2 etc.) indicate models with minus tolerance for corner R(r).
Description Ref. Page for Toolholder
DC..07 type E14~17,E19~21,F29,F51~52
DC..11 type E14~17,E19~21,F29,F44,F51~52
For grades TN30 PV60 PR905 , See Page B75
PV30 PV90 PR915
Inserts are sold in 10 piece boxes.
B52 : Std. Item : Check Availability R : Std. Item (R-hand Only) kyLo:cSetrda.@Itekmyo(Lc-ehraan-dtoOonlsly.)ru
www.kyocera-tools.ru