Kyocera - Основной каталог 2010-2011 ENG

                                     для заказа - kyocera@kyocera-tools.ru

Applicable Inserts

                                              Applicable Inserts M20

     Toolholder

MRP  …-08                         Tough Edge                   Tough Edge                                   -
     …-10                                                                                          RPMT10T3M0
     …-12                RDMT08T2M0-H                            -                                 RPMT1204M0
     …-16
     …-20                           -                  RPMT1204M0-H                                         -
                                                       RPMT1606M0-H
                                                       RPMT2006M0-H

     Flexible Curved Facing                                        Top Face                                     New ratchet design prevents the
                                                                                                                insert's movement and holds the
                                                       Low cutting force and good chip                          insert firmly in the insert pocket
                                                       evacuation by new chipbreaker                            even when the heavy machining.
                                                       design.                                                  (Only RPMT)
                                                       “-H” type insert has a land at the
                                                       cutting edge which adds edge                                 Bottom Face
                                                       strength.

                                              Insert   Land at Edge                                Features                              Remarks

                                     RPMT10T3M0        No                                          Low Cutting         Even if the workpiece clamp is
                                     RPMT1204M0                                                        Force           weak, or if the workpiece is thin,
                                                                                                                       sharp cutting performance and less
                                     RPMT08T2M0-H      Parallel Land                               Tough Edge          chattering is demonstrated.
                                     RPMT1204M0-H      0.2mm Width
                                     RPMT1606M0-H                                                                      Used in General Roughing.
                                     RPMT2006M0-H

Recommended Cutting Conditions

                                                       Recommended Insert Grade (Cutting Speed Vc: m/min)

                                fz            Cermet                                               PVD Coated Carbide                    Carbide    PCD           M
                             (mm/t)
     Workpiece Material              TN60
                                              TN100M
     Stainless Steel         ~0.4             120~200      120~200                                                     100~180
      Carbon Steel           ~0.6                      TC60120~200120~200
                             ~0.6                               PR630100~180100~180
       Alloy Steel           ~0.5                                        PR730100~18080~150
       Mold Steel            ~0.6                                                 PR830
        Cast Iron                                                                                             PR660
                                                                                                                       PR905
                                                                                                                                PW30
                                                                                                                                         KW10
                                                                                                                                                  KPD001
                                                                                                                                                           KPD010
                                                                                                                                                         Milling
                                                                                                                       100~180

                                                                                                                       80~150

                                                                                                                       60~130

                                                                                                                                100~180  80~150

     Non-ferrous Metals      ~0.6                                                                                                                      100~300
                                                                                                                       : 1st Recommendation : 2nd Recommendation
Note) Reduce the ap by 20-50% when machining with long overhang length or using long shank types.

                                              kyocera@kyocera-tools.ru                                                                                     M125
                                                 www.kyocera-tools.ru