Kyocera - Основной каталог 2010-2011 ENG

                                                                      для заказа - kyocera@kyocera-tools.ru

Applicable chamfering Insert                                          Description              Dimension (mm)            PVD Coated             Applicable
                         Insert                                                                  W1 T                       Carbide             Toolholders

                                                                                                                         PR0315               S20-CH10
                                                          8
                                                                      CT08T2-45A               8             2.83

                                                                      5 CT12T3-45A 12 3.98                                                      S32-CH12
                                                                                                                                                S32-CH18
                                                                                                                                                                        ~
 Method to use DRC chamfering attachment                                                       . Drill location check                                                                         Drilling
. Drilling depth adjustment
                                                                                                                                  $
                                                          Hexagon wrench (4)
                                                                                                          Flute

       5 54                                                                                                                                                             Drill fitting
Drilling depth                                                                                                                                                          screw (2)

                       Adjusting screw (1)                                                     #"

nsert drill into chamfering attachment.                                                        Rotate the drill so that the lower end of the chamfering insert A is                                   K
Next, temporarily attach the chamfering insert A.                                              aligned with the body clearance B of the drill.
Turn the adjustment screw (1) with the hexagon wrench (4) to set the                           Set it so that slot C and the drill tting screws (2) are lined up as shown
drilling depth T.                                                                              in the gure above.

. Fix the drill                                                                                . Installation of the chamfering insert

                                                                                                                                                              Wrench (5)

Hexagon wrench (4)                                                    Drill fitting screw (2)                            Press lightly
                                                                                                                        Chamfering insert A
Tighten the drill tting screws (2) with the hexagon wrench (4).
(In the case of using a torque wrench, then please refer to the table                                                                 Insert mounting screw (3)
below)                                                                                         Press the chamfering insert A lightly into the drill and tighten the insert
                                                                                               mounting screw (3) with wrench (5).

Chamfering attachment  Tightening Torque                              Adjusting                Drill tting  Insert mounting         Hexagon    Wrench(5)
                               [Nm]                                   screw(1)                 screw(2)          screw(3)            wrench(4)     DT-9

S20-CH10               10 AJ-6 38                                                                FS-10             MT-3                 LW-3      DT-15
                                                                                                 FS-12
S32-CH12               15 AJ-8 44-9.5                                                            FS-14
                                                                                                 FS-16
S32-CH14               20                                                                        FS-18

                                                                                                                   MT-4              LW-4
                                                                                                                                     LW-5
S32-CH16               30 AJ-10 46

S32-CH18               45

: Std. Item     : Check Availability R : Std. Item (R-hand Only) L : Std. Item (L-hand Only)                                          Inserts are sold
                                                                                                                                     in 10 piece boxes
                                                                         kyocera@kyocera-tools.ru                                                                                      K11
                                                                            www.kyocera-tools.ru