Kyocera - Основной каталог 2010-2011 ENG
для заказа - kyocera@kyocera-tools.ru Chamfering attachment
MagicDrill® DRC type
Chamfering attachment
Drilling and chamfering simultaneously
By using the chamfering attachment, the SS-DRC type can perform drilling and chamfering in parallel.
Toolholder
-
%T -4
Drilling 7 Length adjustment drilling depth.
5 5TApplicable Drill Dia.Dimension (mm)
Ds
%DescriptionStd. Applicable Inserts
% V
D D2 L LS
52 17 CT08T2-45A
S20-CH10 10 20 29 122 21
S32-CH12 12 38 133 62 16
S32-CH14 14 40 137
S32-CH16 42 141 CT12T3-45A
S32-CH18 32 47 144 19
16 15
18
K Note) Chamfering attachment is dedicated for Straight Shank SS-DRC type.
It cannot be used for Flanged Shank SF-DRC type.
Drilling and chamfering depths
%D
Cutting Dia. (mm) Drilling depth (mm) Chamfering
T (5D Drill) dimension (mm)
Dc T (3D Drill) T (8D Drill) Applicable
Ts Toolholders
min max
min max 11 19 min max min max Ts 100 Ts max
7.94 8.49 12 21
8.50 8.99 12 23 21 37 47 63
9.00 9.49 13 25
9.50 9.99 13 26 24 40 51 67 S20-CH10
10.00 10.49 14 28 2.5 5.0
10.50 10.99 14 30
11.00 11.49 15 32 27 43 56 72
11.50 11.99 15 30
12.00 12.49 17 32 31 47 61 77
12.50 12.99 19 34
13.00 13.49 21 36 28 49 60 81
13.50 13.99 19 37
14.00 14.49 21 39 31 52 64 85 S32-CH12
14.50 14.99 25 43 3.5 7.0
15.00 15.99 30 44
16.00 16.99 35 49 34 55 69 90
17.00 17.99
37 58 73 94
41 56 79 94
44 59 83 96 S32-CH14
4.0 8.0
47 62 88 103
51 66 93 108
50 68 94 112
53 71 98 116 4.0 8.0 S32-CH16
59 77 107 125
66 80 117 131 4.0 8.0 S32-CH18
73 87 127 141
Ts 100: Max chamfering dimension at the full feed
Ts max: Max chamfering dimension at a 50% feed reduction
(Max chamfering dimension of machining possible without step feeding)
: Std. Item : Check Availability R : Std. Item (R-hand Only) L : Std. Item (L-hand Only)
K10 kyocera@kyocera-tools.ru
www.kyocera-tools.ru