Kyocera - Основной каталог 2010-2011 ENG

    C5h5i°pDbiaremaoknedr/NSeegleactitvioen/w(iNtдhлeяgHзаaкoазtlаiev- keyocIenra@skeyorcetr)a-tools.ru

                      Low Carbon Steel / Sticky Material

                 Cutting                   Design             Advantages                  Cutting          Design                 Advantages
                           Name                                                                    Name
                                                                                                                             0.2  Consistent chip
B Range                                                                                   Range                            9      breaking at
                                                                                                                                  medium cutting
                                                    0.18                                                                    0.17  due to moder-
                                                                                                                         7        ate rake face
Insert (Turning)                                                            Consistent    Medium                                  and special
           Finishing                                4 chip breaking                                                            3  design.

                      XP                                      performance                           XQ                            Consistent
                                                                                                                                  chip breaking
                                                    0.11      when machin-                                                        when roughing
                                                                                                                                  due to special
                                                                              ing sticky                                          rake face and
                                                   8 materials.                                                                   rake angle
                                                                                                                                  design.
    Finishing         XP-T                               0.2  Tough edge                  Roughing  XS           0.2
                                                              type of XP                                     7
                                                    4         chipbreaker                              XS
                                                       15     for finishing.                          XQ   3
                                                         0.2  Recommended                              XP
                                                              for interrupted
                                                   5          cutting and
                                                     15       unstable
                                                              finishing
                                                              machining.

                      Applicable Chipbreaker Range

                                     (mm)       (Low Carbon Steel)
                                        5           (Sticky Material)

                                        4

                                 ap  3

                                     2               XS
                                            XP      XQ

                                     1 XP-T

                                           0.1 0.2 0.3 0.4 0.5
                                                 f (mm/rev)

B6                                                            kyocera@kyocera-tools.ru
                                                                 www.kyocera-tools.ru