Ниже представлена эта же страница в формате, позволяющем производить копирование текста.

Kyocera - Каталог Токарный инструмент 2016 ENG

                                                                    для заказа - kyocera@kyocera-tools.ru                                               GRADES                   A

GUIDE FOR GROOVING [GVF INSERT]                                                                                                                         INSERTS                  B
                                                                                                                                                                                 C
 Guide for External Grooving (Continued)                                                                   Before turning, pull the tool back          CBN & PCD
  P oint (I) (Turning after Grooving)                                                                     about 0.1mm after grooving.
                                                                                                            (Grooving Depth Over 0.5mm: At roughing)
         1) Grooving Depth Over 0.5mm: At roughing (Refer to Fig.4)
            Before turning, pull the tool back about 0.1mm after grooving, instead                                               Fig.4
            of turning subsequent to grooving.
            (Failure to pull the tool back before traverse machining will result in an                                                                  TOOLHOLDERS SMALL TOOLS  D
            unbalanced load applied on only one side of the cutting edge.)

         2) Grooving Depth under 0.5mm: At finishing (Refer to Fig.5)
            Turning subsequent to grooving is possible because shallow groove
            depths relate a small load on the cutting edge.
            (Retention time is not necessary.)

                                                                                                            Turning subsequent to grooving is           BORING                   E
                                                                                                            possible because there is only a small                               F
                                                                                                            force on the cutting edge.
                                                                                                            (Grooving Depth under 0.5mm: At finishing)

                                                                                                                                 Fig.5

 P oint (II)                                                                                                                                          GROOVING                 G
                                                                                                                                                                                 H
       1) When widening the groove width, apply the “Step Turning” as shown                                                                                                      J
          in Fig. 6.

       2) The widened groove and side walls should be finished last.
          (For better chip control, ap over 0.5mm is recommended.)

                                                                                                                   0.1mm

                                                                                                            Fig.6                                       CUT-OFF

 T rouble shooting                                                        Countermeasures                                                             THREADING

                     Trouble

                              (1) Increase the cutting speed for finishing                   90 ° ±5                                                   HSK TOOLING SPARE PARTS  N
                                  process only.
Whitish trace remains at          (This can handle most of the cases.)                               Fig.7
the groove bottom.                If the method is not successful,
                                  try (2) as follows.
                                                                                                                                                                                 P
                              [ ](2) Check the insert edge’s parallelness.
                                  Adjustment: Apply the insert edge to
                                  the work face and adjust the toolholder
                                  within the angle of ±5'. (Fig.7)

                              (1) Install the toolholder in the reverse position.                                                                       TECHNICAL                R
                                  Adjust the coolant flow to the cutting edge.
Chips are entangled.
                              (2) When widening the groove, do not machine one deep groove.
                                  Instead, repeat shallow grooving and turning.

                                                                                                                                                        INDEX                    T

Insert cracks when turning. Reverse the facing direction.

Groove is not straight.       Check the edge's parallelness.
                              Decrease the feed rate.

                                                              kyocera@kyocera-tools.ru                                    G131
                                                                 www.kyocera-tools.ru
Заявка