Ниже представлена эта же страница в формате, позволяющем производить копирование текста.

Kyocera - Каталог Токарный инструмент 2016 ENG

                                                                        для заказа - kyocera@kyocera-tools.ru      Before turning, pull the tool back
                                                                                                                   about 0.1mm after grooving.
GUIDE FOR GROOVING [GVF INSERT]                                                                                    (Grooving Depth Over 0.5mm: At roughing)

 Guide for External Grooving                                                                                                           Fig.1
  P oint (I) (Turning after Grooving)
                                                                                                                   Turning subsequent to grooving is
         1) Grooving Depth Over 0.5mm: At roughing (Refer to Fig.1)                                                possible because there is only a small
            Before turning, pull the tool back about 0.1mm after grooving, instead of                              force on the cutting edge.
            turning subsequent to grooving.                                                                        (Grooving Depth under 0.5mm: At finishing)
            (Failure to pull the tool back before traverse machining will result in an
            unbalanced load applied on only one side of the cutting edge.)                                                              Fig.2

         2) Grooving Depth under 0.5mm: At finishing (Refer to Fig.2)
            Turning subsequent to grooving is possible because shallow groove
            depths relate a small load on the cutting edge.
            (Retention time is not necessary.)

  P oint (II)

         1) When widening the groove width
            (Refer to Fig.3), apply the “Step Turning” as shown in Fig.3.

         2) The widened groove and side walls should be finished last.
            (For better chip control, ap over 0.5mm is recommended.)

         Note) If the workpiece is not supported at the center, reduce
            the feed rate when grooving towards center.

                                                                                                   0.1mm

                                                                                                       Fig.3

          Guide for Face Grooving

G 

                    (1) Choose the best tool depending on the groove width.
                        The Cutting Dia. D listed in the catalog indicates the depth

                        of the first plunge of face grooving as shown in Fig.1.
GROOVING

                                                                                                                                                                                      D MIN.
                                                                                                                                                                                           W

                                                                                                                                                                                                          D MAX.

       (2) Confirm Grooving Depth (dimension T)                                                                    T
                                                                                                                     Fig.1
      (3) It is recommended to install the toolholder in the
         reverse position. (Fig. 2)                                                    Toolholder  Right-hand (R)  Toolholder  Left-hand (L)
         (This will provide smooth chip flow and chip clearance.)                         Insert     (No Hand)        Insert    (No Hand)

      

      Turning direction should be from the outer diameter
      to the inner diameter as shown in Fig.3
      This improves chip evacuation.

                                                                                                               Fig.2 Toolholder's Hand and Rotation

      Fig.3

G130         kyocera@kyocera-tools.ru
                www.kyocera-tools.ru
Заявка