Kyocera - Каталог Токарный инструмент 2016 ENG
для заказа - kyocera@kyocera-tools.ru
CHIPBREAKER SELECTION (POSITIVE INSERTS)
Steel
2 Ground Chipbreaker
Finishing Good chip control Large rake angle GRADES A
(Without Indication) and low cutting B
14° during finishing to Finishing A m force. Narrow C
light machining chipbreaker width D
with low cutting and consistent E
forces. chip control. INSERTS
Finishing m Good chip control Finishing-Medium Genera purpose CBN & PCD
during finishing to chipbreaker
F light machining B for medium
with low cutting m machining.
Good balance
forces. between chip
control and sharp
cutting. TOOLHOLDERS SMALL TOOLS
Finishing-Medium m Sharp cutting Medium Applicable to high
performance and load machining.
Y good surface C m Good chip
flow and less
finish. resistance.
14° Slant chipbreaker Finishing-Medium F3° BORING
Low Feed width and chip Sharp cutting
J control at various H performance
and small curled
D.O.C.. chips.
GROOVING G
Good chip control Specification of A, B, C and parallel ground chipbreaker
Low Feed 30° at low feed rate
and varied D.O.C.
U with low cutting 8 CUT-OFF
force. Suitable for _ 3 H
automatic lathes.
Insert Type Size Chipbreaker Name W (in) R (in) THREADING J
N
1/4 A 0.040 17° 0.020 P
TPGR 1/4, 3/8 B 0.060 14° 0.020 HSK TOOLING SPARE PARTS
SPGR
3/8 C 0.087 14° 0.040
3/8 Without Indication (Similar to B) 0.060 14° 0.020
1/2 Without Indication (Similar to C) 0.087 14° 0.040
Applicable Chipbreaker Range (D.O.C. Refers to Radial Depth of Cut)
D.O.C. (in) .02 (5/32” I.C.: Steel) %0$ JO
*$4UFFM
TECHNICALR
F/FSF T
.002 .004 .006 .008 e B11
Feed Rate (ipr)
4UFFM
*$4UFFM
INDEX
.16 (1/4”I.C. Steel) 'FFE3BUF JQS
) *$
.12 .16 (3/8”I.C. Steel)
U / USF ) *$
.12 U / USF "#
D.O.C. (in) .08 D.O.C. (in) %0$ JO
$ %0$ JO
J .08
J / JSF
.04
F / FSF .04
F / FSF
.004 .008 .012 .016
Feed Rate (ipr) .004 .008 .012 .016
Feed Rate (ipr) 'FFE3BUF JQS
'FFE3BUF JQS
kyocera@kyocera-tools.ru
www.kyocera-tools.ru