Kyocera - Каталог Токарный инструмент 2016 ENG
для заказа - kyocera@kyocera-tools.ru
CHIPBREAKER SELECTION (POSITIVE INSERTS)
Steel
1 Molded Chipbreaker
Minute D.O.C. CF 20° Available for Finishing PP 10° 3-step Smart
GF minute D.O.C. DP m Dot structure is
Finishing GQ 7.5° (0.0008" - 0.008") Finishing GP 20° applicable to a
SK finishing. VF wide range of
Finishing-Medium CK 5° Finishing HQ feed rates in steel
WP Dot located close G finishing. Smooth
GK 18° to ridge line of taper cutting edge
cutting edge on reduces cutting
13° corner. Chips forces.
20° fragmented in Consistent
small pieces in chip breaking
m cutting of small performance for
D.O.C.. finishing.
0.004” Enables cutting
17° over a wide range Good chip control
of conditions at finishing.
0.004” by using the Applicable to
17° optimum sticky material like
chipbreaker width low carbon steel,
according to the pipe material.
cutting depth.
Finishing Sharp cutting Finishing m Good chip control
performance due for varied ap such
Finishing to Large rake Finishing-Medium m as copying and
angle. Large dot undercutting.
to the corner 0.008”
edge improved 5° 15°
chip control in a General purpose
wide feed rate 0.008” chipbreaker
range. 5° for medium
Good cutting
performance. 15° machining.
Applicable without
Finishing hand for two Medium Chipbreaker
direction cutting m for short chips
on automatic m at medium
lathe. machining.
Dual-dot structure
Finishing-Medium with one dot Medium Strong edge
offering stabilized Standard m chipbreaker
for medium
m chip control at low machining range.
feed rates, while
a second dot
controls chips at
higher feed rates.
Good chip
evacuation at
wide range by
breaker dot and
wide chip pocket.
Applicable Chipbreaker Range (D.O.C. Refers to Radial Depth of Cut)
(Steel) (Steel)
*$4UFFM
.16 (Steel)
.20 .20
.16 D.O.C. (in) .16 D.O.C. (in) .12
.12 CK (,
D.O.C. (in) D.O.C. (in) .12 %0$ JO
.08
GQ .12 General purpose
.08
.08 .08 'FFE3BUF JQS
PP PP
.04 WP (1/4”I.C. Steel) (3/8”I.C. Steel)
*$4UFFM
.04 GF .04 SK .004 .008 .012 .016 .020 .04
CF Feed Rate (ipr)
Finishing 92
.002 .004 .006 .008 .002 .004 .006 .008 .004 .008 .012 .016
Feed Rate (ipr) Feed Rate (ipr) )2 Feed Rate (ipr)
*$4UFFM
*$4UFFM
91
91 *$4UFFM
*$4UFFM
4UBOEBSE
(1
(
%0$ JO
%0$ JO
%0$ JO
%0$ JO
%0$ JO
)2
$' 7' 7'
%1
(1
'FFE3BUF JQS
'FFE3BUF JQS
'FFE3BUF JQS
kyoce'raFF@Ek3yBoUFce JQraS
-tools.ru
www.kyocera-tools.ru 'FFE3BUF JQS
B10