Kyocera - Инструмент для обработки мелких деталей 2016 ENG

                                                              для заказа - kyocera@kyocera-tools.ru

        MEW                                                                               P  Carbon Steel / Alloy Steel                    

         Milling Inserts                                                                    Mold Steel                                    

A  GRADES                                                     Classification of Usage        Austenitic Stainless Steel                 
                                                               : Roughing / 1st Choice
B                                                              : Roughing / 2nd Choice   M  Martensitic Stainless Steel             
                                                               : Finishing / 1st Choice
C                                                              : Finishing / 2nd Choice  K  Precipitation Hardened Stainless Steel     
                                                              In case hardness is under   N
                                         Insert               45HRC                       S  Gray Cast Iron                                   
                                                                                          H
E Handed Insert shows Right-handINSERTS                                                      Nodular Cast Iron                                

F                                                                                            Non-Ferrous Metal
                        General Purpose
                                                                                             Heat-resistant Alloy                    
G
                                                                                             Titanium Alloy                             
                       Low Cutting Force
   CBN & PCD                                                                                 Hard Materials                                
H
                                                              Dimensions (inch)                                    Angle             CVD MEGACOAT NANO
                           Tough Edge
                          (Heavy Milling)        Part Number                                                                         CA6535
                                                                                                                                              PR1535
J  TURNING                                                    A T d W Z r                                                                          PR1525
                                                                                                                                                                  PR1510

                                                 LOMU 100408ER-GM 0.260 0.157 0.134 0.429 0.067 0.031        -     -      - 

   BORING

   GROOVING                                      LOMU 100408ER-SM 0.260 0.157 0.134 0.429 0.067 0.031        -     -      - 

   CUT-OFF                                       LOMU 100408ER-GH 0.260 0.157 0.134 0.429 0.067 0.031        -     -      - 

L  SOLID END MILLS THREADING

M  MILLING

P  SPARE PARTS

R  TECHNICAL

T  INDEX

                                                                                                     EM10

   M10                                                        kyocera@kyocera-tools.ru                                          Inserts are sold in 10 piece boxes
                                                                 www.kyocera-tools.ru
                                                                                                                                                     U.S. Stock Standard : 
                                                                                                                World Express (Shipping: 7-10 Business Days) :