Kyocera - Основной каталог 2011-2012 ENG

                                                                                   для заказа - kyocera@kyocera-tools.ru

                Guide for tool selection

                 Introduction                                                                                                                                                                                          L10~L14
                                                                                                                                                                                                                       L10~L14
                Surface finish oriented

                F Series   MEGACOAT is applied           MEGACOAT and sharp cutting edges enable high precision
                                                         finishing owing to excellent wear and heat-resistance. Total
                                                         lengths 35mm and 45mm are available for automatic lathes.

                                                (FES)

                Multi-purpose                                                                                                                                                                                          L15~L17
                                                                                                                                                                                                                       L16
                PSeries                                  Multi-purpose endmill for slotting and shouldering. Core diameter
                    (PGS)                                ratio is 60% for 1D distance from the bottom edge, and 80% for
                                                         the longer distance. Smooth chip evacuation and high rigidity.

                                                (PGS)

                High efficiency chip evacuation                                                                                                                                                                        L18~L23
                                                                                                                                                                                                                       L18
L Z Series                 MEGACOAT is applied           Multi-functional, high efficiency. Applicable for plunge milling,
                                                         slotting and finishing with one endmill. Smooth chip

                                                         evacuation because the sub-groove on the gash breaks chips
                                                         during plunge milling.

                                                (3ZEKS)

Solid End Mill                                           Varied interval flute design reduces vibration and A             B

                Y Series                                 improve efficiency at slotting and shouldering.

                           (4YEKM, 4YECM, 4YERM)         Applicable for stainless steel and heat resistant
                                                                                                                                                                                                                  A>B
                                                                                                                                                                                                                       L20
                                                         steel with 3 types of cutting edge. (corner land, 4YECM varied interval flute
                                                         chamfered, radius)

    D Series               (5DEKM, 5DERM)                Varied interval flute design with 5 flutes. For high efficiency                                                                                               L21
    R Series                       (RDS)                 slotting and shouldering.
                                   (RFS)                 Applicable for difficult-to-cut materials like stainless steel and heat
L6                                                       resistant steel.

                                                         RDS type is for general use with large flat surface                                                                                                           L22~L23

                                                         edge with a 20 degree helix angle.

                                                         RFS has notched surface edge of 45 degrees helix
                                                         angle. RFS has a notched surface edge with a 45
                                                         degree helix angle.

                                                         для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru