для заказа - kyocera@kyocera-tools.ru
Coolant
1 Internal coolant is recommended. 2 In case of external coolant 3 Dry cutting is not recommended.
In case of horizontal M/C Lathe: 3D or less Vertical M/C: 1.5D or less
K
Internal coolant is recommended for horizontal machining center because external coolant may not sufficiently be applied to inside because the tool is revolving.
Precautions for use If drill is rotating Drilling
Core Deviation
If drill is stationary
max.
0.02mm
max.
0.02mm
This is to be used with a boring sleeve (screw clamp) and colletchuck, Make sure to use arbor that is not deformed.
please be sure to set deviation amount under 0.02mm between workpiece Center of arbor deviation must be within 0.02mm.
and drill.
Cautions for installation on Machining Center
For installation of DRC type MagicDrill,
use Hydro Chuck, Power Chuck, Collet Chuck, etc.
For side lock arbor, tool life is shortened due to drilling center deviation. Hole shape failure may occur.
Hydro Chuck
Power Chuck Install MagicDrill DRC
Collet Chuck to above chuck
1st Recommendation Example of side lock arbor
2nd Recommendation
для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru K17
