Kyocera - Основной каталог 2011-2012 ENG

                                                                      для заказа - kyocera@kyocera-tools.ru

Applicable chamfering Inserts                                                                  Dimensions (mm) PVD Coated Carbide                   Applicable
                         Insert                                                                                                                     Toolholders
                                                                      Description
                                                                 45
                                                          W1                                   W1 T                                   PR0315

                                                                      CT08T2-45A 8 2.83                                                             S20-CH10

                                                                      T CT12T3-45A             12            3.98                                   S32-CH12
                                                                                                                                                    S32-CH18
                                                                                                                                                                           ~
  Method to use DRC chamfering attachment                                                      . Drill location check                                                                            Drilling
. Drilling depth adjustment
                                                                                                                                   C
                                                           Hexagon wrench 4
                                                                                                           Flute

     T TS                                                                                                                                                                  Drill fitting
Cutting Depth                                                                                                                                                              screw (2)

                                  Adjustment screw (1)                                         BA

Insert drill into chamfering attachment.                                                       Rotate the drill so that the lower end of the chamfering insert A is                                      K
Next, temporarily attach the chamfering insert A.                                              aligned with the body clearance B of the drill.
Turn the adjusting screw (1) with the hexagon wrench (4) to set the                            Set it so that slot C and the drill tting screws (2) are lined up as shown
drilling depth T.                                                                              in the gure above.

. Fix the drill                                                                                . Installation of the chamfering insert

                                                                                                                                                                 Wrench (5)

Hexagon wrench (4)                                                    Drill fitting screw (2)                           Press lightly

Tighten the drill tting screws (2) with the hexagon wrench (4).                                                          Chamfering insert A
 In the case of using a torque wrench, then please refer to the table
below)                                                                                                                                 Insert mounting screw (3)
                                                                                               Press the chamfering insert A lightly into the drill and tighten the insert
                                                                                               mounting screw (3) with wrench (5).

Chamfering attachment              Tightening                           Adjusting              Drill tting  Insert mounting           Hexagon      Wrench (5)
                                  Torque [Nm]                           screw (1)              screw (2)         screw (3)            wrench (4)        DT-9
          S20-CH10                                                      AJ-638
          S32-CH12                      10                            AJ-844-9.5                FS-10             MT-3                  LW-3
          S32-CH14                      15                                                       FS-12
          S32-CH16                      20                             AJ-1046                  FS-14             MT-4                       LW-4                         DT-15
          S32-CH18                      30                                                       FS-16                                        LW-5
                                        45                                                       FS-18

: Std. Item : Check Availability                                                                                                                     Inserts are sold
                                                                                                                                                    in 10 piece boxes
                                  для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru                                                                                              K11