Kyocera - Основной каталог 2011-2012 ENG
для заказа - kyocera@kyocera-tools.ru
Small Diameter Face Grooving Toolholders [GVF-AA Insert]
GFVS-AA
T
H1 H3 B 2F
L1 L2 Fac(eToGorouotevrindgiaD.)ia. D (ToFoaucteerGdrioao.)ving Dia. D
h
Right-hand Shown Left-hand Shown
L-hand Insert for R-hand Toolholder, R-hand Insert for L-hand Toolholder.
GFVT-AA Without Offset ( 10mm, 12mm)
G
16
F
T H1 H3 B
4
h 2 L2 L1
oGurtoeorvdiniag.)Dia. D Fig.1 Fac(TeoGorouotevrindgiaD.)ia. D
Face Left-hand Shown
(To L-hand Insert for R-hand Toolholder, R-hand Insert for L-hand Toolholder.
Grooving Right-hand Shown
With Offset ( 16mm, 20mm, 25mm)
F H1 H3 B
T
L2 L1
h2
oGurtoeorvdiniag.)Dia. D Face(TGorooouvtienrgdDiaia.). D
Face Left-hand Shown
(To L-hand Insert for R-hand Toolholder, R-hand Insert for L-hand Toolholder.
Fig.2
Right-hand Shown
Toolholder Dimensions Std. Dimension (mm) Face Grooving Dia. Drawing Spare Parts Applicable Inserts
Description R L H1 h H3 B L1 L2 F D G77
Clamp Set Wrench
T MIN. MAX.
GFVS 1010F-08AA 10 10 10 80 15
GFVT 1212H-08AA
1616H-08AA 12 12 12 100 16 8 ( ) - CPS-5V FT-15 GVFL/R100-005AA
2020K-08AA 16 16 5.5 16 100 18 20 2.2 (0) CPS-5V FT-15 GVFL/R300-005AA
2525M-08AA 20 20 20 125 25
1010F-08AA GVFL/R100-005AA
1212H-08AA 25 25 25 150 32 GVFL/R300-005AA
1616H-08AA
2020K-08AA 10 10 10 80 20 10 Fig.1
2525M-08AA 12 12 12 100 12
8
16 16 5.5 16 100 20 2.2 (0) ( ) Fig.2
20 20 20 125 14 25
25 25 25 150 32
Note 1: Dimension T shows available grooving depth.
2. The value ( ) of Face Grooving External Dia. (D Max) is the maximum outer diameter value after the initial groove between MIN~MAX. (It is possible to widen the groove to
infinity ).
The value ( ) of Face Grooving External Dia. (D Min) is the minimum diameter of the boss which remains in the center when widening the groove width to a smaller value after the
initial groove between MIN~MAX.
: Std. Item
: Check Availability
G76 для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru