Kyocera - Основной каталог 2011-2012 ENG

                                         для заказа - kyocera@kyocera-tools.ru

           Heat-Resistant Alloy (PR13 Series)                                                                     Titanium Alloy (SW Series)

           Applicable Chipbreaker Range (ap indicates radius)                                                     Applicable Chipbreaker Range (ap indicates radius)  B

               (mm)      (Heat-Resistant Alloys)                                                                       (mm)      (Titanium Alloys)                    Insert (Turning)
                 4              TK                                                                                       4   TK
                                                                                                                             MU
                 3                                                                                                       3

           ap                  MU                                                                                 ap   2 MQ
               2                                                                                                       1
                                                                                                                             MS
                     MQ
               1 MS

                         0.1 0.2 0.3 0.4 0.5                                                                                 0.1 0.2 0.3 0.4 0.5

                              f (mm/rev)                                                                                           f (mm/rev)

           Low Carbon Steel (Pipe / Rolled Plate / Rolled Steel)

Cutting                  Design                Advantages                                               Cutting              Design             Advantages
         Name                                                                                                    Name

Range                                                                                                   Range

                                   0.18                                                                                              0.2        Consistent

Finishing                          4 Short chips                                                                                     9 chip breaking

                                               when nishing                                            Medium                                  at medium

           XP                      0.11        due to sharp                                                       XQ                 0.17 cutting due

                                               cutting and                                                                                      to moderate

                                 8 special design.                                                                                   7 rake face and

                                                                                                                                     3 special design.

Finishing                                                           0.2 Tough edge                      Roughing  XS                       0.2  Consistent
                                                               4 type for                                                              7        chip breaking
                                                                                                                     XS                         when roughing
                                                                                           finishing.               XQ               3          due to special
                                                                  15 Recommended                                     XP                         rake face and
           XP-T 0.2 for interrupted                                                                                                             rake angle
                                                                                                                                                design.
                                                                                           cutting and
                                                              5 unstable

                                                                                           finishing
                                                                15 cutting.

           Applicable Chipbreaker Range (ap indicates radius)

                   (mm)         (Low Carbon Steel)
                      5

                     4

               ap    3

                     2              XS
                            XP     XQ

                     1 XP-T

                         0.1 0.2 0.3 0.4 0.5
                               f (mm/rev)

                                                                                                                                                                      B7

                                 для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru