Kyocera - Основной каталог 2011-2012 ENG
для заказа - kyocera@kyocera-tools.ru
C5h5i°pDbiaremaoknedr/NSeegleactitvioen/w(iNthegHaotlieve Insert)
Steel
1 Molded Chipbreaker
B Cutting Design Advantages Cutting Design Advantages
Name Name
Range 0.1 Good chip
Range 7 control for vari-
0.12 ous ap such
Insert (Turning) Wiper Insert. Finishing-Medium 12 as copying.
Finishing-Medium (With Wiper Edge) Finishing (With Wiper Edge) Double feed Applicable
0.09 rate is available for up facing.
for nishing
WP 5 20 to light cutting, CQ
while maintain-
ing a smooth
nish.
Wiper Insert. Finishing-Medium (Up Facing) Improved
0.16 Double 0.1 chip curing at
8 feed rate 7 small cutting
possible while 20 and high feed
WQ 0.3 maintaining a CJ rate cutting.
smooth finish. 0.2
Improved chip
4 High efficiency 15 evacuation at
and good chip copying and up
control. facing.
Medium-Roughing 0.12 Strong edge
Finishing Finishing to chipbreaker.
27 8 Stable for
GP 10 light cutting. GS continuous
Good chip 0.12 cutting
control. and light
27 8 interrupted
cutting.
Finishing-Medium Sharp cutting Medium-Roughing Strong edge
performance 0.24 chipbreaker
and wide
0.1 range chip 15 for general
HQ 15 control with
3-D rake angle purpose
and double
projection cutting.
design. 0.31
CS 0.14 Stable for
continuous
15
15 cutting
and light
interrupted
cutting.
Applicable Chipbreaker Range
(mm) (Steel) (mm) (mm) (mm)
5 (Steel / Edge Length=12,16) (Steel / Edge Length=12) (Steel / Edge Length=16)
4 WQ
3 (r=1.2) 5 5 10
ap ap 4 ap Standard ap 8 PS(HS)
GP (Including DP)
4 GT 6
3 CQ
CJ PS(HS) Standard
3
2 4
2 2
1 2
1 WQ 1 GS PT CQ
WP HQ
0.1 0.2 0.3 0.4 0.5 0.2 0.4 0.6 0.8 1.0
0.1 0.2 0.3 0.4 0.5 0.6 0.1 0.2 0.3 0.4 0.5 f (mm/rev)
f (mm/rev) f (mm/rev) f (mm/rev)
B4
для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru