Kyocera - Основной каталог 2010-2011 ENG

                                           для заказа - kyocera@kyocera-tools.ru

How to adjust cutting edge height

Screw names:                                                                                             Adjustable height for the cutting edge

MSE45-SF                                                      MTE90-SF                                      For model MSE45-SF: approx. 20m
                                                                                                            For model MTE90-SF: approx. 50m
              Clamp screw                                                                                (The difference in adjustable heights varies
                                                                                                         because of the difference in corner angles.)

              Cartridge screw

                                       Adjustment screw

*For the explanations below, refer to the screw names indicated above. Milling Cutter shown here is model MSE45-SF.

1) Partial adjustment of the adjustment screw                 2) Partial tightening of the clamp screw and cartridge screw

   Loosen the edge adjustment screw                                                                         Note)                                          Note)
   Tighten as much as the edge adjustment screw is tensioned
                                                              Partial tighten the cartridge screw.                 Partial tighten the cartridge screw.

Tightening

                                                                        Tightening                                              Tightening

              Loosening                                       *Perform work with all inserts attached in their correct positions.
3) Measuring the cutting edge fluctuation
                                                              Note) Partial tightening: Tighten the adjustment screw only partially, so that further
                                                                      adjustment is still possible.

              Example: Measuring the front cutting edge fluctuation

                                                                                                         No.       Measurement  Results     Edge
                                                                                                                       results           uctuation
                                                                                                                                 Max.
                                                                                                                   0.263mm        Min.       -6m                 M
                                                                                                                                            -11m
                                                                                                                   0.258mm                  -15m

                                                                                                                   0.254mm                    0m
                                                                                                                                             -8m
                                                                                                                   0.269mm                  -19m

                                                                                                                   0.261mm

                                                                                                                   0.250mm                                        Milling

                                                                                                                   Current uctuation: 19m

                                                                                                         (Number ~ are not indicated on Milling Cutter)

              *With each of these screws partial tightened: cartridge
               screw, clamp screw, adjustment screw, measure the
               cutting edge uctuation.

4) Correcting the fluctuation                                 5) Firm tightening of the cartridge and insert

Based on the measurement results, correct the fluctuation.    Fully tighten the cartridge screw                      Fully tighten the clamp screw

                                                                                                                                         Tightening

                                           Tightening                                                    Tightening

Using the measured amount of uctuation, adjust so that the uctuation is corrected                                                                               M29
at the highest corner of the cutting edge, then fully tighten the adjusting screw.

                                                                               kyocera@kyocera-tools.ru
                                                                                  www.kyocera-tools.ru