Kyocera - Основной каталог 2010-2011 ENG
для заказа - kyocera@kyocera-tools.ru
4UGSM, 6UGSM
Semi-Finishing of Hard Materials Recommended Material Number of Flutes: 4, 6
1st Recommendation
%D I
%T
Shank Dia.
Aluminum Non-ferrous Metal Difficult-to-Cut Material Hardened material General Use
-
46
Lineup (Unit: mm)
Description Std. Outside Dia. Outside Dia. Edge Length Shank Dia. Total length Number of Flutes
Dc tolerance Ds L Z
4UGSM030-080-06 50 4
4UGSM040-120-06 3 -0.014 8 6
4UGSM050-130-06 -0.028
6UGSM060-150-06
6UGSM080-200-08 4 -0.020 12 6 57 4
6UGSM100-250-10 -0.038
6UGSM120-300-12
6UGSM160-400-16 5 -0.020 13 6 57 4
-0.038
6 -0.020 15 6 60 6
-0.038
8 -0.025 20 8 75 6
-0.047
10 -0.025 25 10 80 6
-0.047
12 -0.032 30 12 100 6
-0.059
16 -0.032 40 16 110 6 L
-0.059
In order to achieve stable machining of hard materials, negative type rake angle is adopted. Also, for attaining high efciency, we pro-
vide six utes type for dia. over 6mm.
Recommended Cutting Conditions Solid End Mill
Shouldering
Workpiece Materials Depth of Cut (apae) (mm) Outside Dia. (mm) 4 6 8 10 12 16
8,000 6,000 4,800 4,000 3,000
BQ 45~55HRC 1Dc0.05Dc Spindle Revolution (min-1) 11,900 1,200 1,200 1,000 980 900
1Dc0.05Dc Feed Rate (mm/min) 810 5,300 4,000 3,200 2,700 2,000
BF 55~60HRC 1Dc0.2Dc Spindle Revolution (min-1) 8,000 760 740 610 610 540
Steel Feed Rate (mm/min) 510 3,500 2,600 2,100 1,700 1,300
Shouldering Spindle Revolution (min-1) 5,200 480 450 390 370 330
60~65HRC Feed Rate (mm/min) 290 1,900 1,400 1,100 900 700
250 230 200 200 170
65~70HRC 1Dc0.2Dc Spindle Revolution (min-1) 2,800
Feed Rate (mm/min) 150
Not Recommended for Slotting.
: Std. Item : Check Availability R : Std. Item (R-hand Only) L : Std. Item (L-hand Only)
kyocera@kyocera-tools.ru L31
www.kyocera-tools.ru