для заказа - kyocera@kyocera-tools.ru
General Use End Mill End mill for difcult-to-cut materials, cast iron, and steel machining L10~L24
MEGACOAT is applied
Finishing For nishing. Beautiful surface nish is achieved by high quality cutting edges and MEGACOAT that
has excellent wear resistance and heat resistance.
F Series (FES) For semi-nishing. High efciency machining products such as the 3-edge square
(3UEBS) type and ball-nose end mill have been added to the lineup.
Semi-
Finishing
U Series
Roughing (RDS) Applicable for machining of wide variety of steel such as stainless steel, cast iron,
and etc. The sine curve shaped cutting edge reduces cutting resistance and controls
R Series chatter.
End mill applicable for End mill developed primarily for machining of hard materials. Also suitable for steel L25~L34
hard materials machining.
MEGACOAT is applied
Finishing
Applicable for finishing of hard materials. MEGACOAT Hard is adopted. Achieves stable
machining of hardened materials.
H Series
(HFS)
Semi- (UGS) (PGS) (6PDRS)
Finishing
For stable and high efciency machining of hard Good chip evacuation and high rigidity. Short, High efficiency radius. Achieves large machining
P, U Series materials. Medium and Long are available. allowance and high efciency machining with special
corner radius shape.
L Roughing For rough copying / proling. Strong cutting edge suitable for machining of hard materials and
titanium alloys.
R Series
(3 / 4RFRS)
Solid End Mill End mill for End mill designed for difcult-to-cut materials, such as stainless steel, inconel and titanium.
difcult-to-cut materials L35~L38
Semi- Wide enough unequally partitioned flute design reduces vibration and achives
Finishing high efciency machining. 5 kinds of edges such as sharp edge, chamfered, land,
radius and ball-nose are available.
Y Series
(4YECM, 4YERM, 4YEKM)
4YECM varied interval ute
High Feed 5 edge unequally partitioned design. Achieves machining of difficult-to-cut materials, such as
Rate stainless steel and heat-resistant alloy at high feed rates.
D Series (5DEKM, 5DERM)
End mill for aluminum & End mills available for finishing, semi finishing and roughing of aluminum & non-ferrous
non-ferrous materials
materials. L39~L43
Finishing A wiper is attached at the lower edge for improving bottom surface nish. Chattering is controlled
with cutting edge slots at varied intervals, and nishing of lateral surfaces is improved.
N Series (3NESM)
Semi- Achieves good chip evacuation with special rake face
Finishing shape and 45° helix angle.
N Series (2 NFSM) (3 NFSM)
Roughing (3AESM) For roughing of Aluminum / Non-ferrous Metal. Achieves high efciency machining with a large chip
evacuation space.
A Series
kyocera@kyocera-tools.ru
L4 www.kyocera-tools.ru
