для заказа - kyocera@kyocera-tools.ru
New product introduction PDR type
HFS type High efciency radius end mill for
hard materials
End mill for nishing of hard materials
4,5,6,7HFSS 4,5,6,7,8HFSM 6PDRS
MEGACOAT is applied
with Corner land HFS cross section FES cross section PDR type General Purpose Ball-Nosed End Mill
For nishing of hard materials For high efciency machining of hard materials
End mill for hard materials that achieves longer tool life Improved productivity with 6 edge design and high
and stable machining. feed rate.
Applicable for hard materials up to 67HRC.
Achieves high feed rate machining for cutting of hard materials. Special corner-R shape with the large contact area
Compared to the FES type, the core diameter was on the bottom surface achieves large machining
increased by 30%, for higher rigidity. allowance and high efciency machining.
Negative rake angle and stronger cutting edge design with corner land.
Applicable for hard materials up to 67HRC.
L25, L26
L
DEK type , DER type
L32 Solid End Mill
End mill for high feed rate machining
of difcult-to-cut materials NES type
End mill for nishing of aluminum &
non-ferrous materials
5DEKM, 5DERM with wiper edge 3NESM
For high efciency machining of difcult-to-cut materials For nishing of aluminum
Achieves high feed rate machining with 5 edge design A wiper is attached at the lower edge for improving bot-
Achieves high efficiency machining for difficult-to-cut tom surface nish.
materials, such as stainless steel and heat-resistant alloys. Chattering is controlled with cutting edge slots at varied
Applicable for slotting with a cutting depth up to 0.8D. intervals, and nishing of lateral surfaces is improved.
Unequally partitioned flute design prevents vibration and A special core shape facilitates improved chip evacuation,
reduces cutting force. while assuring rigidity.
Able to accommodate work from roughing to nishing Able to accommodate work from roughing to nishing
with a single tool. with a single tool.
L37 L39
kyocera@kyocera-tools.ru L3
www.kyocera-tools.ru
