Kyocera - Основной каталог 2010-2011 ENG
для заказа - kyocera@kyocera-tools.ru
Cut-Off Toolholders
Available cut-off diameter of KGM / KGM-T type
There is a limit to available grooving depth depending on the workpiece diameter.
20 (Dimension t)
18
130
40 (D: Cut-Off Dia.)
25
When the workpiece diameter becomes large, the available grooving
depth becomes smaller due to interferes with toolholder.
H
Machining Example: KGMR2525M-3T20+GMN3
Cut-off KGM (For Automatic Lathe) Available Cutting Dia. Table
Toolholder D (Cut-Off Dia.)
KGM 0810K-1.5-125 - - - - - - - - - - - - 10 14 16 32
1010K-1.5-125 - - - - - - - 20 25 32 40 60
1212F-1.5-85 - - - - 25 26 28 32 36 40 60 100
1212M-1.5-150
0810K-2-125 - - - - - - - - - - - - 10 14 16 32
1010K-2-125 - - - - - - - 20 25 32 40 60
1212F-2-85
1212M-2-150 - - - - 25 26 28 50
1616M-2-150 32 40 50 60 80 100
1010K-2.5-125 - - - - - - - 20 25 32 40 60
1212F-2.5-85 - - - - 25 26 28 32 36 40 60 100
1212M-2.5-150
1616M-2.5-150 32 40 50 60 80 100
1616M-3-150 32 40 50 60 80 100
Grooving Depth t (mm) 16 15 14 13 12.5 12 11 10 9 8 7 6 5 4 3 2 1
KGM-T Available Cutting Dia. Table (GMN, GM type When using 1-edge inserts)
Toolholder D (Cutting Dia.)
KGM 2012K-2T17 ------ - - 66 80 130 260 under 13
2020K-2T17 ------ - - 66 80 130 260
2525M-2T17 ------ - - 66 80 130 260
1616H-3T20 - - - - - 40 54 70 100 180
2012K-3T20 - - - - - 40 90 130 240 14
2020K-3T20 - - - - - 40 90 130 240
2525M-3T20 - - - - - 40 90 130 240
2020K-4T20 - - - - - 40 90 130 240
2525M-4T20 - - - - - 40 90 130 240
2525M-4T25 - - 50 140 240
2525M-5T25 - - 50 140 240 19 18 17 16 15
3232P-5T25 - - 50 280 600
2525M-6T30 100 300
30 27 25 23 22 20
Grooving Depth t (mm)
Std. Stock
H14 kyocera@kyocera-tools.ru
www.kyocera-tools.ru