Kyocera - Основной каталог 2010-2011 ENG
C5h5i°pDbi aremaoknedr/ для заказа - kyocera@kyocera-tools.ru
NSeegleactitvioen/w(iNthegHaotlieve Insert)
Steel
1 Molded Chipbreaker
B Cutting Design Advantages Cutting Design Advantages
Name Name
Range 0.1 Good chip con-
Range 7 trol at varied ap
0.12 such as copy-
Insert (Turning) Wiper Insert. Finishing-Medium 12 ing. Applicable
Finishing-Medium (With Wiper Edge) Finishing (With Wiper Edge) to up facing.
Double feed
0.09 rate is available
WP at nishing to CQ
5 20 light cutting,
while maintain-
ing a smooth
nish.
Wiper Insert. Finishing-Medium (Up Facing) Improved chip
0.16 Double 0.1 curing at small
8 feed rate 7 cutting and
possible while 20 high feed rate
WQ 0.3 maintaining a CJ 0.2 machining.
smooth finish. Improved chip
4 High efficiency 15 evacuation at
and good chip copying and up
control. facing.
Medium-Roughing 0.12 Strong edge
Finishing Finishing to chipbreaker.
27 8 Stable at
GP 10 light cutting. GS continuous
Good chip 0.12 machining
control. and light
27 8 interrupted
cutting.
Finishing-Medium Sharp cutting Medium-Roughing Strong edge
performance 0.24 chipbreaker
and wide
0.1 range chip 15 for general
HQ 15 control with
3-D rake angle purpose
and double
projection machining.
design. 0.31
CS 0.14 Stable at
continuous
15
15 machining
and light
interrupted
cutting.
Applicable Chipbreaker Range
(mm) (Steel) (mm) (mm) (mm)
5 (Steel / Edge Length=12,16) (Steel / Edge Length=12) (Steel / Edge Length=16)
5 5 10
ap 4 WQ ap 4 ap Standard ap 8 PS(HS)
(r=1.2) 3 GP (Including DP) CQ 6
4 GT 4
3 CJ
2 PS(HS)
3
1
2 2 Standard
HQ
1 WQ 0.1 0.2 0.3 0.4 0.5 1 GS PT 2
WP CQ
f (mm/rev)
0.1 0.2 0.3 0.4 0.5 0.6 0.1 0.2 0.3 0.4 0.5 0.2 0.4 0.6 0.8 1.0
f (mm/rev) f (mm/rev) f (mm/rev)
B4 kyocera@kyocera-tools.ru
www.kyocera-tools.ru