Kyocera - Основной каталог 2010-2011 ENG

                                                             для заказа - kyocera@kyocera-tools.ru                                                                        Screw Clamp

Application of SVJB C                                                                             , S SVJP

[Toolholder Refer Page for details F36 (Dynamic Bar), F62]

1. Application Range

                                         -SVJB 16-50

                                             -SVJB 16-40

                                                             -SVJB 11-30                                                                    A
                                                                     -SVJB 11-25
                                                                                                                                                                                                     Boring
            50                                                              -SVJC 08-20                           R A/2                                               L2
                                                                                      -SVJC 08-16                      L2
                      40                                                              -SVJP 08-16
                                     30
                                                                 16
                                                         25
                      VB

                      1604 type          VB                  20

                                         1103 type

                                                                 VCP                                                                                                                                     F
                                                                  0802 type

2. Machining method                                                                                      d=0.5mm                                    Finishing
                                                                                                   (r= 0.4)
                                    Case with No Existing Hole                                                                              Spherical Machining

                                                                                         d=0.5mm
                                                                                  (r= 0.4)

Spherical Machining                                              Internal Facing

            (Note) f shall be under 0.05mm/rev at internal facing.                                                                          Internal Facing

                       Case with Drilled Hole

                                       Spherical
                                       Machining

            Drilled Hole                     Internal
                                             Facing

                                                                                                                                            Machining Process
                                                                                                                                               Finish the internal face first.
                                                                                                                                               Next, finish the internal diameter

            (Note) f shall be under 0.05mm/rev at internal facing.

3. Caution

                                                                                                                                            16 Spherical Machining

                                             When machining past the center of the workpiece,                                               R8
                                             insert breakage may occur.                                                                                      R7.6

                                                                                                                                                           (r= 0.4)

                                                                                                               Fix the insert edge at the   Adjust the machining program of
                                                                                                               center of the workpiece.     radius smaller by Corner-R (r) value.

                                                                                                  For internal profiling, ap should
                                                                                                  be less than the value of Corner-R (r).

                                                                                                                  ap

                                             Machining of this kind is available,                                              Less than Corner-R (r)
                                             but the oblique part may be scratched by chips.
                                                                                                                  [Burs may occur, if ap is bigger than Corner-R (r).]

                      Poor finish

                                                                 kyocera@kyocera-tools.ru                                                                                              F35
                                                                    www.kyocera-tools.ru