Ниже представлена эта же страница в формате, позволяющем производить копирование текста.

Kyocera - Каталог Токарный инструмент 2016 ENG

                                                                    для заказа - kyocera@kyocera-tools.ru                                               AGRADES
                                                                                                                                                        B
FACE GROOVING TOOLHOLDERS (SWITCHBLADE TYPE)                                                                                                            CINSERTS
                                                                                                                                                        D
 Face Grooving Dia. D                                                                                                                                 E
                                                                                                                                                        F
     Face grooving diameter (D) is the                                                                                                                 G
     suitable value for the initial grooving on                                                                                                         H
     the unprocessed workpiece                                                                                                                          J
     (Ref. Fig.1).                                                                                                                                      N
     Then, you can widen it up to the center                                                                                                            P
     towards the inside (excluding the models                                                                                                           R
     listed in the right table) and towards the                                                                                                         T
     outside according to machine limits.
                                                                                          %.*/                                                 G85
                                                                                              8

                                                                                                              %."9

                                                                                  5                                                                      CBN & PCD

                                                                                   Fig.1                                                                 TOOLHOLDERS SMALL TOOLS

 Limit of Turning toward Center

Turning towards the Center causes the toolholder to interfere with the groove wall depending on the initial cut's diameter.

                                                                                          D (mm)

                                  Part Number                                     25      26                          27  28 and
                                                                                                                           over
E d (mm)
                                                                                                                                                         BORING
                        KGDF§ 2020X25-3AS                                         420
                                     2525X25-3AS

      %                KGDF§ 2020X25-4AS                                         630                                     (No remaining Boss) 0          GROOVING
*OUFSGFSFODF                         2525X25-4AS                                  741

                        KGDF§ 2020X25-5AS
                                     2525X25-5AS

Remaining Boss Dia. d  KGDF§ 2020X25-6AS                                         941                                                                    CUT-OFF
                                     2525X25-6AS

e.g.)                                                                                                                                                    THREADING
If a groove of external diameter 25mm is created using KGDFR2020X25-3AS
and turning is made toward the inside, a 4mm portion will be left in middle due
to interference of toolholder.

                                                                                                                                                         HSK TOOLING SPARE PARTS

                                                                                                                                                         TECHNICAL

                                                                                                                                                 INDEX

                                  kyocera@kyocera-tools.ru
                                     www.kyocera-tools.ru
Заявка