Ниже представлена эта же страница в формате, позволяющем производить копирование текста.

Kyocera - Каталог Токарный инструмент 2016 ENG

                                                                             для заказа - kyocera@kyocera-tools.ru

     SUMMARY OF FACE GROOVING

      Face Grooving Dia. D

        Face grooving diameter (D) is the
        suitable value for the initial grooving on
        the unprocessed workpiece.
        (Ref. to Fig.1).
GROOVING
                                                                                                                                                       %.*/5
                                                                                                                                                            8
                                                                                                                                                                           %."9Fig.1

      Caution for Face Grooving

     1) When face grooving, the suitable toolholder depends on the length of the boss

     Boss                Interference between  Boss  No interference between
                         toolholder and boss         toolholder and boss

G 2) Selection of Face Grooving Toolholder                                                                                                                                                                 Good

  EXTERNAL                                                                                                                                                                                                 Poor
   INTERNAL
                                                                                                                                                                                   •	 Example of usage for the
        FACE                                                                                                                                                                            face grooving toolholder. When face
                                                                                                                                                                                        grooving, KFMSR2525M70100-4
                         Shape of below Jaw          Shape of below Jaw                                                                                                                 should be between 70~100
                                                                                                                                                                                        for grooving the outer diameter at
     Shape of below Jaw                                                                                                                                                                 first. If the workpiece is machined
                                                                                                                                                                                        at a diameter 100 or 70, the
                  Wider grooving (turning) should be                                                                                                                                    jaw of toolholder interferes with the
                performed from the outside inwards.                                                                                                                                     workpiece.

     3) Interference of Face Grooving Toolholder

             e.g.) KFMSR2525M70100-4

                                                                              Interference under 70

     Interference
     more than
     100

G72                                                  kyocera@kyocera-tools.ru
                                                        www.kyocera-tools.ru
Заявка