Kyocera - Каталог Токарный инструмент 2016 ENG

                                                     для заказа - kyocera@kyocera-tools.ru

DOUBLE CLAMP SERIES

High Rigidity Toolholder

Double-Clamp Series

Securely Clamps the Insert with a Single Action

         Improved Clamping Rigidity

D  Force to pin down insert.
TOOLHOLDERS                                                           Tighten the screw.
                                                                                                                                                          Cutting Edge Side Force to pull back insert.
                                                                                                                                                                                                  Cutting Edge Side
 L ong Insert Life

The double-clamp design firmly clamps the insert in two directions, which maintains good contact between the shim and the insert
even during high feed rate machining. Along with improving the accuracy of the insert position, greater insert life is attained.

  Double                                                              Comparison of shim and insert contact
  Clamp                                                            
  (DCLN)                                                                  Coating material is applied to the shim side of the insert, which is installed on the toolholder.
                                                                          Compare the shim contact surface after tightening.
   Lever                                                          
    Lock                                                             PS Chipbreaker                                 Shim Contact Surface Shim Contact Surface
  (PCLN)  5 10 15 20 25 30                                                                                           of Double-Clamp                                                                                 of Lever Lock
Passes
                                                                                                                     The shape of the insert breaker   Only a part of the shape of the
                                                                                                 is transferred indicating a high  insert breaker is transferred
SCM435, Vc (sfm)=490, D.O.C.=0.039", f (ipr)=0.016"                                                                  level of contact.                 indicating a low level of contact.
CNMG432PS, 30 Pass Interrupted Machining

 C onvenient Marking Design

                                                                      The spare part descriptions and the screw tightening            Screw                                                                          Tightening Torque
                                                                      torque are conveniently located on the toolholder body.
                                                                                                                                      CS-2D                                                                          1.7 N·m (1.25Ib.ft)
                                                                                                                                      CS-3D                                                                          3.9 N·m (2.88Ib.ft)
                                                                                                                                      CS-5D                                                                          3.0 N·m (2.21Ib.ft)

                                                                                           kyocera@kyocera-tools.ru

D2 www.kyocera-tools.ru