Kyocera - Каталог фрезерование 2017 ENG
для заказа - kyocera@kyocera-tools.ru
MSE45-SF
How to Adjust Cutting Edge Height MTE90-SF Adjustable Height for the Cutting Edge
Screw Names • For model MSE45-SF: Approx. 0.02mm
MSE45-SF • For model MTE90-SF: Approx. 0.05mm
(The difference in adjustable height varies
Clamp Screw because of the difference in corner angles.)
Cartridge Screw
Adjustment Screw45 / 70 LEAD
C * For the explanations below, refer to the screw names indicated above.
1) Partial Adjustment of the Adjustment Screw 2) Partial Tightening of the Clamp Screw and Cartridge Screw
Loosen the edge adjustment screw
Tighten as much as the edge adjustment screw is tensioned Partial tighten the cartridge screw. Partial tighten the clamp screw.
Tightening
Tightening
Tightening
Loosening * Perform work with all inserts attached in their correct positions.
Notes) Partial tightening: Tighten the adjustment screw only partially, so that further adjustment is still possible.
3) Measuring the Cutting Edge Fluctuation
Example: Measuring the Front Cutting Edge Fluctuation
No. Measurement Results Edge
Results Fluctuation
0.263mm -0.006mm
0.258mm -0.011mm
0.254mm -0.015mm
0.269mm Max. 0mm
0.261mm -0.008mm
0.250mm Min. -0.019mm
Current fluctuation:19m
(Number ~ are not indicated on Milling Cutter)
* With each of these screws partialy tightened: cartridge screw, clamp screw, adjustment screw, measure the cutting edge fluctuation.
4) Correcting the Fluctuation 5) Firm Tightening of the Cartridge and Insert
Based on the measurement results, correct the fluctuation. Fully tighten the cartridge screw.
Tightening
Tightening Tightening
Using the measured amount of fluctuation, adjust so that the fluctuation is corrected at the highest corner of the cutting edge, then fully tighten the adjusting screw.
C20 kyocera@kyocera-tools.ru
www.kyocera-tools.ru