Kyocera - Каталог фрезерование 2017 ENG

                    MRP                                                        для заказа - kyocera@kyocera-tools.ru
                                                         Applicable Inserts  B21
                     Applicable Inserts

                         Part Number

                    MRP …-08                 Tough Edge       Tough Edge                                -
                             …-10       RDMT08T2M0-H                   -                  RPMT10T3M0
                             …-12                                      -                  RPMT1204M0
                             …-16                     -
                             …-20                     -  RPMT1204M0-H                                   -
                                                      -  RPMT1606M0-H                                   -
                                                      -  RPMT2006M0-H

                                                  Top Face                            Ratchet design prevents the insert's movement
                                                                                      and holds the insert firmly in the insert pocket
                                       Low cutting force and good chip evacuation     even during heavy machining.
                                       with new chipbreaker design. “-H” type insert  (Only RPMT)
                                       has a second cutting edge next to the first
                                       cutting edge that adds edge strength.                     Bottom Face

                    Insert Part Number    Land at Edge                                Applications                  Notes

                    RPMT10T3M0                                                                           Even if the workpiece clamp is weak,
                    RPMT1204M0
                                          No                                          Low Cutting Force  or if the workpiece is thin, sharp cutting
                                                                                                         performance and less chattering is

                                                                                                         achieved.

                    RPMT08T2M0-H        Parallel Land 0.008" Width                    Tough Edge         Used for General Roughing.
                    RPMT1204M0-H
                    RPMT1606M0-H
                    RPMT2006M0-H

                     Recommended Cutting Conditions

                                                                    Recommended Insert Grades (Cutting Speed Vc: sfm)

                    Workpiece             Feed Rate                 Cermet                               MEGACOAT                       Carbide
                     Material               fz (ipt)

                                                                    TN100M                PR1230           PR1210                       KW10

RADIUS / BALL-NOSE Carbon Steel           ~0.024                                                              -                            -
                                          ~0.024                    390~820               390~820               -
J Alloy Steel                             ~0.020                                                                -                            -
                                          ~0.016                                                              -
                   Mold Steel             ~0.024                    330~590               330~720                                           -
                   Stainless Steel        ~0.024                                                           330~720
                   Cast Iron                                                                                  -                            -
                   Non-ferrous Metals                               330~590               260~590                                           
                                                                                                                                        260~490
                                                                                                                                          
                                                                    390~660               390~720                                       330~980

                                                                         -                     -

                                                                         -                     -

                    Notes) Reduce the D.O.C. by 20-50% when machining with long overhang                 : 1st Recommendation : 2nd Recommendation
                             length or using long shank types.

J24                                                                                       kyocera@kyocera-tools.ru
                                                                                             www.kyocera-tools.ru