Kyocera - Каталог фрезерование 2017 ENG
для заказа - kyocera@kyocera-tools.ru
MSTC SLOT MILL (LAY-DOWN / HALF SIDE)
Changing the Slot Width (Edge Width) Set up the slot mill on length measuring equipment such as tool GRADES A
presetters. B
8FEHF4DSFX 8FEHF C
Insert a 3mm Hexagon Wrench (TH-3L) into the wedge screw. D
LINEUP / INSERTS 45 / 70 LEAD E
Turn TH-3L counterclockwise to loosen the Wedge. F
G
Turn TH-3L clockwise by the torque of 1 N·m to tighten the wedge H
lightly and make the wedge contact the cartridge and the J
Slot Mill body. K
In doing so, some resistance occurs against the cartridge. O
P
-PPTFOJOH 5JHIUFOJOH R
T
5)- 75 LEAD
)FYBHPO8SFODIXJUINN8JEUI
)FYBHPO8SFODI $BSUSJEHF Insert a Hexagon Wrench (LW-2.5 or LW-3) into the Cam Pin on 90 LEAD
the back of the cartridge.
HIGH FEED
Turn the wrench and adjust the position of the Cartridge.
To secure the adjustment, back-turn the Cam Pin and make
sure that it does not touch the groove surface of the back of
the Cartridge.
Remove the Hexagon wrench from the Cam Pin.
$BN1JO Insert TH-3L into the Wedge Screw. MULTI-FUNCTION SLOT MILLS RADIUS / BALL-NOSE OTHER APPLICATIONS TOOL HOLDING SPARE PARTS
8FEHF4DSFX
Tighten the Wedge Screw by the torque of 5-6N·m.
(Use a torque wrench to get the correct torque.)
Make sure there is no gap between the Cartridge and the
Slot Mill body.
.BLFTVSFUIFSFJTOPHBQ
3FDPNNFOEFE5JHIUFOJOH
5PSRVF /sN
5)-
TECHNICAL
INDEX
kyocera@kyocera-tools.ru H25
www.kyocera-tools.ru