Kyocera - Инструмент для обработки мелких деталей 2016 ENG

       BASIC FORMULAS (Inch)                                       для заказа - kyocera@kyocera-tools.ru
         T urning
                                                                                               B oring
A
   GRADES

B  INSERTS

C  CBN & PCD

E Surface Speed per MinuteTURNING                                                            Metal Removal Rate

                               SFM= 0.262  DIA  RPM                                                     Q= 12  DOC  IPR  SFM (in3/minute)

                              Revolutions per Minute                                         Horsepower Required at the Spindle
   BORING                                        3.820  SFM
F                             RPM=                    DIA                                                 HPS= Q  UHP

                              Feedrate (inches/minute)                                       Horsepower Required at the Motor
                                                                                                          HPS
                                           IPM= IPR  RPM                                    HPM=         EFF

G  GROOVING                   Chip Thinning for Non-Round Inserts (inches/revolution)        Time in Cut (seconds)
                                                 tchip Max                                   T=	          15.7  DIA  LOC
                              Programme	 d IPR=                                                               SFM  IPR
                                                    cos1

                              Chip Thinning for Round Inserts (inches/revolution)            or
                                                                                             T	 =         60  LOC
   CUT-OFF                    Prog	rammed IPR= tchip Max                                                     IPM
( )H                                             4ap  -  2ap  2
                                                 ic      ic

         E xternal GroovingSOLID END MILLS THREADING                                        Internal Grooving

J

L

M  MILLING

P  SPARE PARTS

R  TECHNICAL                  Surface Speed per Minute                                       Metal Removal Rate

                                           SFM= 0.262  DIA  RPM                                         Q= 12  WOC  IPR  SFM (cu.in/minute)

                              Revolutions per Minute                                         Horsepower Required at the Spindle
                                                 3.820  SFM
                              RPM=                    DIA                                                 HPS= Q  UHP

T Feedrate (inches/minute)INDEX                                                              Horsepower Required at the Motor
                                                                                                          HPS
                              IPM= IPR  RPM                                                 HPM=         EFF

                              Feedrate (inches/revolution)                                   Time in Cut (seconds)
                                                                                             T=	 7.85  DOC  (DIA + DIAG)
                                           IPR= tchip                                                                SFM  IPR

                                                                                             or
                                                                                             T	=          60  LOC
                                                                                                             IPM

   R28                                                             kyocera@kyocera-tools.ru
                                                                      www.kyocera-tools.ru