Kyocera - Инструмент для обработки мелких деталей 2016 ENG

                                                                                                      для заказа - kyocera@kyocera-tools.ru

                              CHIPBREAKER SELECTION (POSITIVE INSERTS)

           SteelGRADES       Minute D.O.C.             Available for                                                                           Good chip control
                                                        minute D.O.C.                                                                           at finishing.
                   1 Molded Chipbreaker                 (0.02 to 0.2mm)      Finishing         GP                                               Applicable to
                                                        finishing.                             GK                                               sticky material like
A  INSERTS                                              Dot located close                                                                       low carbon steel,
                                                        to ridge line of                                                                        pipe material.
                    CFCBN & PCDFinishing                cutting edge on      Finishing-Medium                                                   Good chip
                                                        corner. Chips                                                                           evacuation at
B                                                       fragmented in                                                                           wide range by
                                                        small pieces in                                                                         breaker dot and
C GF                                                    cutting of small                                                                        wide chip pocket.
                                                        D.O.C..
                                                                                                                                                General purpose
E  TURNING                    Finishing-Medium          Enables cutting      Finishing-Medium                                                   chipbreaker for
                                                        over a wide range                                                                       medium cutting.
                   GQ                                   of conditions                          HQ
                                                        by using the
F  BORING                                               optimum
                                                        chipbreaker width
                                                        according to the
                                                        cutting depth.

   GROOVING                                             Good cutting         Finishing                                                          Wide chip control
             Finishing                                  performance.                                                                            range and
G CK                                                    Applicable without                     XP                                               sharp cutting
H  CUT-OFF                    Medium                    hand for two         Finishing-Medium  XQ                                               performance.
J                                    Standard (without  direction cutting                                                                       Suitable for low
   SOLID END MILLS THREADING                            on automatic                                                                            carbon steel and
                                         Symbol)        lathe.                                                                                  sticky material.
                                                        Strong edge                                                                             Wide chip control
                                                        chipbreaker for                                                                         range and
                                                        medium cutting                                                                          sharp cutting
                                                        range.                                                                                  performance.
                                                                                                                                                Suitable for low
                                                                                                                                                carbon steel and
                                                                                                                                                sticky material.

L                             Finishing                 3-step Smart
                                                        Dot structure is
                    PPMILLING                           applicable to a
                                                        wide range of
M                                                       feed rates in steel
                                                        finishing. Smooth
                                                        taper cutting edge
                                                        reduces cutting
                                                        forces.

                                                        Applicable Chipbreaker Range (D.O.C. indicates radial depth per side of the workpiece)

P  SPARE PARTS

R  TECHNICAL

T  INDEX

   B4 kyocera@kyocera-tools.ru
                                                                                                  www.kyocera-tools.ru