Kyocera - Основной каталог 2011-2012 ENG
для заказа - kyocera@kyocera-tools.ru
Cut-Off Inserts
TKN / TK Classification of usage P Carbon Steel andAlloy Steel TN90
CR9025
Insert : Continuous-Low Interruption / 1st Choice M Stainless Steel PR660
: Continuous-Low Interruption / 2nd Choice K Cast Iron PR930
Handed RInigshetr-thsahnodwSshoRwignht-hand N Non-ferrous Metals KW10 Carbide
: Continuous / 1st Choice
: Continuous / 2nd Choice Ref. Page for Applicable
Toolholder
Dimension Angle Cermet CVD PVD
(mm) (°) Coated Coated Carbide
Carbide
Description
W r
TKN 1.6 1.6 0.15
2 2.2 0.20
W 0.05 2.4 2.4 0.20 -
3 3.1 0.25
4 4.1 0.30
4.8 4.8 0.30
5 5.1 0.30
6 6.4 0.35
8 8.0 0.40
9 9.6 0.45
W 0.05 TKN 1.6-P 1.6 0.20 - H22 H
2-P 2.2 0.20 H24
3-P 3.1 0.25
Low Feed
TK 1.6 1.6 0.15 R
2 R
2.4 2.2 0.20 R R
3
W 0.05 4 2.4 0.20 8° R Cut-off
5 3.1 0.25
4.1 0.30 R
Lead Angle 5.1 0.30
W 0.05 TK 1.6-P 1.6 0.20 R RR
2-P RR
3-P 2.2 0.20 8° R RR
3.1 0.25 RR
Low Feed / Lead-Angled
Cut-Off Tools Chipbreaker For recommended cutting conditions, see page H25
Cutting Range Advantage
Standard
General Cut-Off (No General cut-off type for feed rates over 0.1mm/rev.
Superior chip evacuation
Indication)
Low Feed Cut-Off P Chipbreaker specially designed for low feed machining on automatic lathes, etc.
Chips are controlled at feed rate 0.03~0.08mm/rev.
Insert’s Edge Shape (CERACUT Cut-Off) Sharp Edge Hone
Chamfer + hone
Edge Shape
Std. Chipbreaker TN90 PR930 / KW10 -
CR9025 / PR660
TN90 / CR9025
P-Chipbreaker - - PR660 / PR930 / KW10
• Sharp Edge Spec. can reduce cutting resistance 40% less than that of chamfer edge.
: Std. Item : Check Availability R : Std. Item (R-hand Only) L : Std. Item (L-hand Only)
Inserts are sold in 10 piece boxes
H21для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru