Kyocera - Основной каталог 2011-2012 ENG
для заказа - kyocera@kyocera-toolGs.rruooving Insert with Molded Chipbreaker
Guide for Grooving
Guide for Grooving with Cermet Insert (Steel)
1. Set the f under 0.12mm/rev (0.05~0.10mm/rev normally).
2. Coolant is recommended.
3. Set the cutting speed VC=150-220m/min.
4. Set the toolholder overhang as short as possible.
How to Improve Surface Finish (when surface roughness below 3 Rz is required)
1. Increase the cutting speed (VC=220m/min.MAX) Chips for Easy
2. Program retention time at the groove bottom. Evacuation
3. Apply a light hone to the cutting edge by hand lapper.
Chip Control of Grooving Insert with Molded Chipbreaker Improved chip control in
sticky materials due to
Advantages of MY Chipbreaker back projections.
1. Molded chipbreaker curls chips spirally and
Good chip control at shoulder
evacuates chips easily. grooving due to the combination of
front rake and front projections.
2. High precision molded Insert with
economical 3 cutting edges.
3. Can be used in automated production.
G
GBA-MY Good surface finish of groove wall due to Less cutting force due to rake
3-Edge Molded Chipbreaker narrow chips' evacuation by the effect of angle 14 -15° when installing
side rake and front projections. on toolholder.
Grooving
Ref. Page
Alternative Toolholder Reference Table for Grooving Toolholder
Conventional Toolholder Alternative Toolholder
Spare Parts
Clamp Screw Wrench Wrench
Overall
Description length Description Overall Remarks
(mm) length
(mm)
KTGF 1010K-16F 125 SB-4070TRW FT-8 - KTGF 1010JX-16F 120 G16
KGM 1212M-16F 150 1212JX-16F 120
KGM 1616M-16F 150 SE-40120TR - LTW-15S KGM 1616JX-16F 120 No
KGM replacement
KGM 0810K-1.5-125 125 SE-40120TR - LTW-15S KGM - -
KGM SE-50125TR - LTW-20 KGM No
1010K-1.5-125 125 SE-40120TR - LTW-15S 1010JX-1.5 120 replacement
1212M-1.5-150 150 SE-50125TR - LTW-20 1212JX-1.5 120
SE-50125TR - LTW-20 G36
0810K-2-125 125 - -
1010K-2-125 125 1010JX-2 120
1212M-2-150 150 1212JX-2 120
1616M-2-150 150 1616JX-2 120
1010K-2.5-125 125 1010JX-2.5 120
1212M-2.5-150 150 1212JX-2.5 120
1616M-2.5-150 150 1616JX-2.5 120
1616M-3-150 150 1616JX-3 120
Note) The corresponding replacements may be different from the conventional parts in insert clamping system or insert size. Make sure their specifications referring to the catalog or other
documents.
G96 для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru