Kyocera - Основной каталог 2011-2012 ENG
для заказа - kyocera@kyocera-tools.ru CERACUT Plunge&Turn
Face Grooving Toolholders
KFMS-8
D T
(Face Grooving Dia)
L1
F L2
H2 h H3 W
H1 B
T Left-hand Shown
Right-hand Shown
Toolholder Dimensions
Std. Dimension (mm) Width Face Grooving Spare Parts Ref. Page for
Recommended
(mm) Dia. D Screw Wrench Cutting Conditions
Description
G R L H1=h H2 H3 B L1 L2 F T W MIN. MAX.
KFMS 2525M5464-8 - 54 64
2525M6382-8
2525M80115-8 2.4 9 41 (0) ( )
2525M105160-8 25
2525M155510-8 63 82
3232P155510-8
Grooving 25 150 26 25 8 (0) ( )
80 115
68 40 (0) ( ) HH6X25 LW-5 G93
105 160
(0) ( )
25 6 25 150 26 155 510
32 - (0) ( )
8 43 25 8
32 170 33
Dimension T shows available grooving depth.
The value ( ) of Face Grooving Dia. (D Max) is the maximum outer diameter value after the initial groove between MIN MAX. (It is possible to widen the groove to infinity ).
The value ( ) of Face Grooving Dia. (D Min) is the minimum diameter of the boss which remains in the center when widening the groove width to a smaller value after the initial groove
between MIN MAX.
Applicable Inserts P Carbon Steel / Alloy Steel Classification of usage
M Stainless Steel
Description L (mm) K Cast Iron : Continuous-Light Interruption /
N Non-ferrous Metals 1st Choice
GMM 8030-080MW 30 H S Titanium Alloy : Continuous-Light Interruption /
GMG 8030-050MG 2nd Choice
GMGA 8030-400R 5.5 Hard materials (under 40HRC) : Continuous / 1st Choice
: Continuous / 2nd Choice
H
Applicable
Hard materials (over 40HRC) Toolholder
Dimension (mm) Cermet PVD Ref. Page for
W r M CVDCoated Toolholder
Carbide
Coated Carbide
(Previous
Description) Carbide
Insert Description TN90
CR9025
PR915
PR930
PR905
KW10
M 22
W 0.05
GMM 8030-080MW GMM 8030-08 8.0 0.8 6.0
L
H
Chip Control Oriented / M Class
W 0.03 L GMG 8030-050MG GMG 8030-05MG 8.0 0.5 6.0 KFMS 8 G86
22
Sharp-Cutting Oriented / 15
Precision Class M
H
Ground Chipbreaker
M GMGA 8030-400R GMGA 8030-40R 8.0 4.0 6.0
W 0.02
L
Sharp-Cutting Oriented / H
Precision Class
Full-R / Copying
If using a full-R insert with KIGM-8 type toolholder, you need to modify the corner of insert adapter of toolholder.
G86 Inserts are sold : Std. Item : Check Availability R : Std. Item (R-hand Only) L : Std. Item (L-hand Only)
in 10 piece boxes. для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru