Kyocera - Основной каталог 2011-2012 ENG
для заказа - kyocera@kyocera-tools.ru Screw Clamp
Internal Large Diameter Shallow Grooving Toolholders [TG Insert] D
KITG (Changes to KIGBA, See Page G43)
A
L2F H
4 TN60 L1
TN90
Right-hand shown TC40L-hand Insert for R-hand Toolholder, R-hand Insert for L-hand Toolholder.
TC60
Toolholder Dimensions Std. Min. Dimension (mm) Spare Parts
Description Cutting Dia. L1 L2 F
Clamp Screw Wrench
R L A D H
G KITG 3525T-16 35 25 23 220 18 17.5 SB-4TR - FT-15 -
4532T-22 45 32 30 250 20 22.5 - LW-3
- GS-50
Available Grooving Depth KITG 3525T-16=2.0mm, KITG 4532T-22=2.5mm J23
* KITG will be switched to KIGBA as an Internal Large Diameter Shallow Grooving Toolholder; however, it will continue to be sold as Internal Threading Toolholder (
GBA Insert cannot be installed to this toolholder.
Grooving Applicable Inserts G12) P Carbon Steel / Alloy Steel Classification of usage
M Stainless Steel
(TG type insert changes to GBA type See page G10 ~ K Cast Iron : Continuous-Light Interruption / 1st Choice
N Non-ferrous Metals : Continuous-Light Interruption / 2nd Choice
(mm) S Titanium Alloy : Continuous / 1st Choice
: Continuous / 2nd Choice
Description A T d Hard materials (under 40HRC)
TG32_ 9.525 3.18 4.5 H
TG43_ 12.70 4.76 5.5 Hard materials (over 40HRC)
Dimension (mm) Cermet Ref. Page for
Toolholder
Insert Description C Applicable Toolholder
W B or
R-hand shown
r
TG32 075 0.75
TG43 095
A W 0.03 125 0.95
C C 145
150
General (Square) B 175 1.25
d 200
150 1.45 2.0 C0.1 KITG 16 G56
175
T 200 1.50
(Corner is C shape) 230
250 1.75
265
TG32 type 280 2.00
300
330 1.50
350
400 1.75 3.5 0.2
430 2.00
450
0.03 2.30
r
A r W 2.50
B 2.65
d
2.80 4.0 KITG 22 G56
3.00 0.3
General (Square)
Corner is R shape) T 3.30
TG43 type 3.50
4.00 5.0 0.4
4.30
4.50
Dimension B: shows available rooving depth. For recommended cutting conditions, see page G90
* KITG will be switched to KIGBA.
* For applicable insert, TG insert changes to GBA.
Change Insert Grade TN60 for TN90.
There are various types of GBA insert materials available depending on the user’s cutting condition requirements.
* Check the cornner-R r of the insert when changing.
G56 Inserts are sold : Std. Item : Check Availability R : Std. Item (R-hand Only) L : Std. Item (L-hand Only)
in 10 piece boxes. для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru