Kyocera - Основной каталог 2011-2012 ENG
для заказа - kyocera@kyocera-tools.ru
Toolholders for Grooving and Cut-off
Toolholder Spare Parts (Common with separate types)
KGD-S (0° separate type) * The parts are included in the toolholder.
Spare Parts
Std. Dimension Clamp Bolt Fixing bolt Wrench
for Insert Clamp (for blade)
Shape of 0° type Description H1
Unit
R-hand Shown Description
KGD 2020-C 104 20 20
H1 B KGD S BH6X10TR SB-60120TR LTW-25
2525-C 129 25 25
L 3232-C 149 32 32 Setting the blade (Separate type toolholder)
KGDS-S (90° separate type) 1. Use compressed air or other measures to remove chips
G Shape of 90° type Std. Dimension and dust from the serration part (see Fig. 4).
2. Mate and fit the serrations of the blade and toolholder,
Description
and also fit the blade end to the toolholder.
R-hand Shown H1 3. Tighten the blade fixing screws at an appropriate torque
(Recommended tightening torque: 8N·m).You can
tighten them in any order.
4. Set the insert after setting the blade.
Blade
Grooving KGDS 2020-C 122 20 20
H1 B 2525-C 147 25 25
L Serration
Blade Fig.1
Std. Dimension Toolholder
Shape of Blade Blade
Description
R-hand Shown
T KGD -2T17-C 51.2 17.2 A
-3T10-C 44.2 10.2
LA -3T20-C 53.2 20.2 1.7 Insert clamp bolt
41.5 -4T10-C 44.2 10.2 2.4
-4T20-C 54.2 20.2
-4T25-C 59.2 25.2 3.4 Blade
-5T10-C 44.2 10.2
-5T25-C 59.2 25.2 4.4
The blade end
should rmly t
to the toolholder.
Separate type Toolholder Identification Fig.2 Blade xing bolt
System and Their Setting to Lathe
Toolholder
Firmly fit the lower jaw to the tool post of the lathe.
Description of Clamp Bolt
Description of Toolholder
Description Toolholder lot No. Std. Item
of Blade Description of Fixing bolt
Toolpost of lathe
Blade lot No.
Firmly fit для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru
G28