Kyocera - Основной каталог 2011-2012 ENG

                                                                             для заказа - kyocera@kyocera-tools.ru

          Summary of KGD Type Grooving

          External Grooving (G22~G31)

          Integral Type                 KGD
                    Type               2.0~8.0
                                        6~30
                Width (mm)
          Grooving Depth (mm)           G26

                 Ref. Page

          Separate Type

                       Type            KGDS-S

G Width (mm)                           3.0

          Grooving Depth (mm)          10

          Ref. Page                    G27

          The separate type toolholders can accept all
          the inserts if their hand is matching.

Grooving                                                                                                            Separate Type

                                                                                                                        Type               KGD-S
                                                                                                                    Width (mm)             2.0~5.0

                                                                                                                    Grooving Depth (mm)    10~25
                                                                                                                           Ref. Page        G27

                                                                                                                    The separate type toolholders can accept all
                                                                                                                    the inserts if their hand is matching.

          Low Cutting        Low Feed       For general  High feed rate General cut-off                                                    Copying
              Force                           purpose
                               GL                            PH PM                                                                          CM
             GS                                GM

          Face Grooving 25~ (G68~G75)                   Grooving and                                                              Deep grooving and
                                                         Longitudinal turning                                                      Longitudinal turning

                                                                  GM                                                                      DM

                                                                                                                               Type        * KGDF
                                                                                                                    Min. Face Groove Dia.     25

                                                                                                                           Width (mm)      3.0~6.0
                                                                                                                    Grooving Depth (mm)     13~32
                                                                                                                                             G70
                                                                                                                            Ref. Page

                                                                                                                    The separate type toolholders can accept all
                                                                                                                    the inserts if their hand is matching.

G2                             для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru