Kyocera - Основной каталог 2011-2012 ENG

                                                             для заказа - kyocera@kyocera-tools.ru                                                                        Screw Clamp

Application of SVJB C                                                                             , S SVJP

[Toolholder Refer Page for details F50 (Dynamic Bar), F54]

1. Application Range

                                       -SVJB 16-50

                                       -SVJB 16-40

                                                             -SVJB 11-30                                                                    A
                                                                     -SVJB 11-25
                                                                                                                                                                                                     Boring
                                                                                                  -SVJC 08-20                 R A/2
                                                                                                                                   L2
            50                                                                                    -SVJC 08-16                                                         L2
                         40                                                                       -SVJP 08-16
                                   30

                                                         25
                      VB

                      1604 type        VB                    20
                                        1103 type
                                                                 16

                                                                 VCP                                                                                                                                     F
                                                                  0802 type

2. Machining method                                                                                                  d=0.5mm                        Finishing
                                                                                                               (r= 0.4)
                                    Case with No Existing Hole                                                                              Spherical Machining

                                                                                         d=0.5mm
                                                                                  (r= 0.4)

Spherical Machining                                              Internal Facing

            (Note) f shall be under 0.05mm/rev for internal facing.                                                                         Internal Facing

                       Case with Drilled Hole

                                       Spherical
                                       Machining

            Drilled Hole               Internal
                                       Facing

                                                                                                                                            Machining Process
                                                                                                                                               Finish the internal face first.
                                                                                                                                               Next, finish the internal diameter

            (Note) f shall be under 0.05mm/rev for internal facing.

3. Caution

                                                                                                                                            16 Spherical Machining

                                       When machining past the center of the workpiece,                                                     R8
                                       insert may break.                                                                                                     R7.6

                                                                                                                                                           (r= 0.4)

                                                                                                               Fix the insert edge at the   Adjust the machining program to
                                                                                                               center of the workpiece.     radius minus the value of Corner-R (r).

                                                                                                  For internal profiling, ap should
                                                                                                  be less than the value of Corner-R (r).

                                                                                                                              ap

                                       This type of machining is possible,                                                                 Less than Corner-R (r)
                                       but the chips might scratch the surface.
                                                                                                                              [Burs may occur, if ap is bigger than Corner-R (r).]

                      Poor finish

                                       для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru                                                                                      F49