Kyocera - Основной каталог 2011-2012 ENG
для заказа - kyocera@kyocera-tools.ru Back Clamp
External Toolholders [CC Insert
ACLC-FF (Without Offset) (External / Facing)S F1 2 5
*Lock Screw is operated from this direction.
5°
16
5 h S F1 H1 B
95 95° L1
95° 0
ACLC$1010JX-09FF
shows above figure.
Right-hand shown L2 H2
E Toolholder Dimensions Dimension (mm) Standard Corner-R(r) Anchor Pin Spare Parts
Lock Screw Wrench
Std.
Description
R L H1=h H2 B L1 L2 F1 S
Small Tools ACLC 1010JX-06FF 10 - 10 120 - 10 LPF-11
1010JX-09FF 10 LPF-13
1212JX-09FF 10 2 10 16 12 0 0.2 LPF-17 HSB4X8 FH-2
1616JX-09FF 16
12 12 120
--
16 16
Lock Screw : HSB48R for R-hand Toolholder, HSB48L for L-hand Toolholder.
Applicable Inserts Finishing Finishing-Medium Finishing-Medium Low Feed Stainless Steel Cast Iron Non-ferrous Metals Non-ferrous Metals Non-ferrous Metals Hard Materials
B45 B45 B45 B48
Applications B46 B47 B46 B46 C18 C10
Ref. Page GF GK GQ (E / F) -U MQ Without Chipbreaker AH -A3 PCD CBN
Insert
Toolholder
ACLC ...-06FF CCGT0602.. CCMT0602.. CCGT0602.. CCGT0602.. - CCGW0602.. - - CCMT0602.. CCMW0602..
ACLC ...-09FF CCGT09T3.. CCGW0602..
CCGT09T3.. CCMT09T3.. CCGT09T3.. CCGT09T3.. CCMT09T3.. CCGW09T3.. CCGT09T3.. CCMT09T3.. CCMW09T3..
CCGW09T3..
For recommended cutting conditions, see page E38
Back Clamp Holders
Simple insert replacement,
including with gang-tooling
1. The lock screw can be operated from the back side and The lock screw
allows simple insert replacement on Swiss type automatic can be operated from
lathes (Fig.1)
the back side.
2. Simple insert replacement by slightly turning the wrench.
3. Rigid clamping with anchor pin and lock screw. (Fig.2)
insert Conventional tool is not
available for gang-tooling.
Anchor Pin
(Fig.1)
Lock
Screw
(Fig.2)
: Std. Item : Check Availability
E20 для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru