Kyocera - Основной каталог 2011-2012 ENG
для заказа - kyocera@kyocera-tools.ru
Applicable Inserts Finishing-Medium Finishing-Medium Finishing-Medium Finishing-Medium Medium-Roughing Medium-Roughing
Application Finishing Finishing-Medium Finishing HQ CQ CJ TK GS PS
WP Wiper WQ Wiper GP
Insert
Size 12 12 09,12 09,12 12,16 12,16 12 09,12 12,16
Page B14 B14 B15 B15
B14 B14 B14 B14 B14
Roughing One side / Roughing• Finishing Medium
Application Medium-Roughing Medium-Roughing Medium-Roughing Medium-Roughing Roughing PH $-S $
High Feed Rate
HS CS PT GT Standard D
PX
Insert
Size 12,16 12 12,16 12 12,16 12,16 12,16 09 09,12
B16
Page B15 B15 B15 B15 Stainless Steel B16 B16 B18 B18
GU
Application Medium-Roughing / Low Soft Steel Soft Steel / Soft Steel / Stainless Finishing Stainless Medium- Stainless Medium- Stainless Medium- External
Cutting Resistance type Finishing Medium cutting Roughing Roughing Roughing Roughing
$-25R XP -T XQ XS MQ MS MU TK
Insert
Size 12 12 12 12 12 12 12 12,16 12
Page B18 B16 B16 B16 B17 B17 B17 B17 B17
Application Cast Iron Cast Iron Non-ferrous Non-ferrous Non-ferrous Hard Materials
Cast Iron Cast Iron Cast Iron Metals Metals Metals
ZS GC CBN
C Without Chipbreaker Ceramic AH A3 PCD
Insert
Size 12,16 12 12 12 12,16 12 12 12 12
C5
Page B17 B17 B18 B18 B85 B18 B18 C17
For recommended cutting conditions, see page D39~D40
Short shank toolholder for small lathe and turning mill
Length of 100mm for 20mm square shank
Optimal toolholder length for small lathe, con- Short shank PCLNR2020H-12
ventionally for which shank was cut off
Available also as toolholder for quick change
system of turning mill
Conventional toolholder PCLNR2020K-12
Conventional Toolholder Short Shank
Toolpost Drum
Large overhang length due to contact of May be set to optional overhang length
shank with toolpost drum. since there is no interference with tool-
post drum.
для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru D9