Kyocera - Основной каталог 2011-2012 ENG

                                             для заказа - kyocera@kyocera-tools.ru

    High rigidity holder

   Double Clamp Series

D Securely clamps the insert with a single action

    Improved Clamping Rigidity

    Firmly clamp the insert in two directions with one action.
External
                  Force to pin down insert.            Tighten the screw
                                                                                                                                                                                     Cutting edge sideForce to pull in insert.
                                                                                                                                                                                                                               Cutting edge side
    Achieving long Insert Life

    By strongly clamping the insert in two directions, good contact between the shim and insert can be maintained, even with
    high feed rates.
    Along with improving the accuracy of the insert position, long insert life can be achieved.

    Double Clamp                                        Comparison of shim and insert contact
    (DCLN type)                                                                   Coating material is applied to the shim side of the insert, which is installed on the tool

                                                        holder. Compare the shim contact surface after tightening.

                                                                 PS Chipbreaker             Shim contact surface Shim contact surface

                                                                                             of double clamp                                                                                                                                      of lever lock

                                                       

    Lever Lock          
    (PCLN type)   

                                               0ASS	

                                                                         The shape of insert    Only a part of the
    34CrMo4(SCM435), Vc=150m/min, ap=1mm, f=0.4mm/rev                                        chipbreaker is         shape of insert chip-
    CNMG120408PS, 30 Pass Interrupted Cutting                                                transferred.           breaker is transferred.
                                                                                             There is a high level  There is a low level of
                                                                                             of contact.            contact.

    Convenient marking design

                                                                                             Screw  Tightening Torque (N•m)

                                                                                             CS-2D            1.7
                                                                                             CS-3D            3.9
                                                                                             CS-5D            3.0

                                                                                             Use the part-description for convenient
                                                                                             ordering. The screw tightening torque is
                                                                                             also indicated.

D2                         для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru