Kyocera - Основной каталог 2011-2012 ENG
для заказа - kyocera@kyocera-tools.ru
For Aluminum Wheel (1-Edge) Classication of usage Non-ferrous Metals (with interruption)
: Light Interruption / 1st Choice N Non-ferrous Metals (without interruption)
: Light Interruption / 2nd Choice
Edge Prep. : Continuous / 1st Choice Titanium Alloy (with interruption) No. of Edges
: Continuous / 2nd Choice Titanium Alloy (without interruption) KPD001
All Items Rounded Cutting Edge (Hone) S KPD010
Dimension (mm) Ref. PagePCD
for Toolholder
Insert Description C
W r L H M S
GMGW 6030-30R 63 5 4.5
r 30 5.5 PCD
8030-40R 84 66
1 G40
r GMGW 8030-40R-HR 8 4 30 5.5 6 5
Traversing / Grooving Inserts (1-Edge) Classication of usage N Non-ferrous Metals (with interruption)
: Light Interruption / 1st Choice Non-ferrous Metals (without interruption)
Edge Prep. : Light Interruption / 2nd Choice Titanium Alloy (with interruption)
: Continuous / 1st Choice Titanium Alloy (without interruption)
All Items Sharp Edge : Continuous / 2nd Choice S No. of Edges
KPD001
Dimension (mm) Angle KPD010 PCD
(°) Ref. Page
for Toolholder
Insert Description W D r T H d S *
max
Handed Insert shows Right-hand TKF12$ 200-AS
rd 250-AS RLRL
r
2.0 10 5.0
±0.03 3 8.7 5 0° 1
W HT 2.5 10 +0 5.5
-0.05
0.1
B TKF16$ 250-AS 2.5 16 4 9.5 5 6.5 0° 1
Grooving Inserts TKF12$ 150-NB H8
200-NB
E 250-NB 1.5 7 2.0
S )5 2.0 8 +0 3.0
-0.05
8 %NBY
S
0.1 3 8.7 5 0° 1
2.5 8 3.0
External Grooving 250-NB4.5 2.5 10 4.5
(Traversing )
* Relief angle (Front cutting edge angle: ) represents the angle when installed in the toolholder.
Note 1) The cutting edge of the TKF..-AS will be 1 mm lower Dmax KTKF type toolholder
than the center line when attached to the KTKF
toolholder (See Fig.1). Adjust the height by making h1 H1 H1
NC lathe parameter settings or inserting a plate.
Fig.1 When a TKF-AS insert is attached
2) If the 1 mm adjustment is not possible on your Dmax (The cutting edge is 1 mm lower than the
automatic lathe, use the TKF..-NB. (See Fig.2.) center line.)
KTKF type toolholder
h
Fig.2 When a TKF-NB insert is attached
: Std. Item (1 pc boxes) CBN & PCD Tools are sold C25
: Check Availability in 1 piece boxes.
для заказа - kyocera@kyocera-tools.ru www.kyocera-tools.ru