Kyocera - Основной каталог 2010-2011 ENG
для заказа - kyocera@kyocera-tools.ru
METS Slot Mill T-Slotting Back side milling
METS
% E Fig.1
EI Fig.2
- -
- -
-
Toolholder Dimensions Std. Dimension (mm) Rake Angle (°) Drawing Spare Parts Applicable
Description No. of Insert
No. of Edge Line Clamp Screw Wrench Inserts
M13
D d d1 L1 L2 L3 L4 L5 A.R. R.R.
METS 21-S25 21 21 25 10.5 9 109 29 32 12 17 -10° SB-2560TR DT-8 SDMT060304E-K
METS 25-S25 42 25 12.5 11 112 32
32-S32
40-S32 32 15.5 14 120 38 +9° Fig.1 SB-3060TR DT-10 SDMT080308E-K
50-S32
21-S25-H 4 2 40 32 20.5 18 130 50 36 14 19 -12° SB-4085TR DT-15 SDMT120408E-K
25-S25-H 50 26.5 22 140 60
32-S32-H
40-S32-H 21 21 25 10.5 9 109 29 32 12 17 -10° SB-2560TR DT-8 SDMT060304E-K
50-S32-H 42 25 12.5 11 112 32
32 15.5 14 120 38 +9° Fig.2 SB-3060TR DT-10 SDMT080308E-K
4 2 40 32 20.5 18 130 50 36 14 19 -12° SB-4085TR DT-15 SDMT120408E-K
50 26.5 22 140 60
METS…-H type has air holes
Applicable Inserts JIS Standard of T-Slot (Extracted from B0952) (Unit: mm)
Applicable Inserts M13 A H
(Nominal Size)
M SDMT 060304E-K B C Max. Min.
SDMT 080308E-K
Toolholder
12 19 +2 8 +1 25 20
0 0
14 23 +2 9 +2 28 23
0 0
MillingMETS 21-S25 18 30 +2 12 +2 36 30
21-S25-H 0 0
CMETS25-S25
HMETS25-S25-H2237+316+34538
0 0
32-S32
32-S32-H 28 46 +4 20 +4 56 48
0 0
40-S32
40-S32-H SDMT 120408E-K A
50-S32 B
50-S32-H
Previous milling groove does not affect.
M138 : Std. Item : Check Availability R : Std. Item (R-hand Only) L : Std. Item (L-hand Only)
kyocera@kyocera-tools.ru
www.kyocera-tools.ru