Kyocera - Основной каталог 2010-2011 ENG
для заказа - kyocera@kyocera-tools.ru
Turning Indexable Inserts
Small Double Sided Tools (mm)
Description A T d
CN_U0703_ 7.5 3.18 3.6
B r P Free-cutting steel
Classification of usage
Negative M
$ Carbon Steel and Alloy Steel
% A K :Interruption / 1st Choice
3 d
4 N Stainless Steel
5 TN6010 :Interruption / 2nd Choice
7 TN6020
8 Gray Cast Iron
TN60 :Light Interruption / 1st Choice
PV7005
PV7010 Nodular Cast Iron
PV7020 :Light Interruption / 2nd Choice
CA5505 Non-ferrous Metals
80 CA5515TS Heat-resistant alloy :Continuous / 1st Choice
CA5525 Titanium Alloy :Continuous / 2nd Choice
CA5535 (In case hardness is under 45HRC)
CA6515H
CA6525 Hard Materials
CA4010
CA4115Dim.CermetPVDPVD
CA4120(mm)CermetCoated Carbide
CA4505
CA4515
PR930
PR1005
PR1025
PR1125
KW10 Carbide
Ref. Page for
Toolholder
CVD Coated Carbide
Insert Description Applicable
Chipbreaker Range
Handed Insert r
shows Right-hand
Medium-Roughing Finishing-Medium CNGU 070301MF-SK < 0.1
070302MF-SK < 0.2
Sharp Edge
Insert (Turning) CNMU 070302E-GK 0.2 (mm) (Steel)
070304E-GK 0.4 4
With Honing U
Sharp Edge 3
Sharp Edge
CNGU 0703005MF -F < 0.05 ap
070301MF -F < 0.1
Finishing 070302MF -F < 0.2 2
070304MF -F < 0.4 SK GK
CNGU 0703005MF -U < 0.05 E4
070301MF -U < 0.1
070302MF -U < 0.2 1
070304MF -U < 0.4
F
0.05 0.1 0.15 0.2
f (mm/rev)
Low Feed
Low Feed CNGU 070301ME -U < 0.1
070302ME -U < 0.2
070304ME -U < 0.4
With Honing
Insert whose corner R(r) dimension expressed with less than sign (e.g. <0.05, <0.1, <0.2 etc.) indicate models with minus tolerance for corner R(r).
Chipbreaker Selection
Cutting Range Name Design Advantages
16° A low cutting force chipbreaker designed for chip control in stainless steel.
Cutting performance is similar to comparable sized positive inserts.
Finishing-Medium SK
Chip breaker “dot” and pocket design provide chip control at multiple depths of
13° cut and feed rates.
0.06
17°
Medium-Roughing GK 0.06
17°
Finishing F 18° Good chip control for nishing to light cutting with low cutting force.
Low Feed 35° Good chip control at low feed rate and varied ap with low cutting force.
U
B38 : Std. Item : Check Availability R : Std. Item (R-hand Only) kyLo:cSetrda.@Itekmyo(Lc-ehraan-dtoOonlsly.)ru Inserts are sold in 10 piece boxes.
www.kyocera-tools.ru