для заказа - kyocera@kyocera-tools.ru
Introduction
Change to New Label
Indication of Cutting Conditions For 2nd recommendation materials, only
round mark is shown
To improve usability, cutting conditions are indicated in the label.
* This will apply to only new insert grades temporarily. Usage Classication by Materials
Indication of Cutting Conditions
P For Carbon Steel / Alloy Steel
M For Stainless Steel / Cast Iron
K For Gray Cast Iron /
Nodular Cast Iron
N For Aluminum / Non-
ferrous Metal / Non-Metal
S For Titaniuml Alloy / Ni Alloy
H For Heat Treated Steel /
Chilled Cast Iron
Corner R
For 1st Recommendation materials, round Cutting Speed
mark and down-arrow are shown and rec-
ommended cutting conditions are indicated Depth of Cut
For Continuous Machining= Cont. Feed
For Light Interruption= Light Int.
For Interruption= Heavy Int. * Upper is Metric (meter)
Lower is Inch
Center Values of Recommended Cutting Conditions
Upper and Lower limits of Rec- Rough=For Heavy Cutting
ommended Cutting Conditions Middle=For Medium Cutting
Finish=For Light Cutting
Dual labeling for the grade PR1025 (PR925) Dual grade indication
TiCN PR925 grade changed to PR1025 and it is
now classied correctly within the new PVD coated
PR1000 series (TiCN) separate from the PR1100
series (TiAlN). For identification purposes, label
indicates both previous and new names, as shown
on right.
Dual label indicates new grade
PR1025 and previous grade PR925
6 kyocera@kyocera-tools.ru
www.kyocera-tools.ru
