для заказа - kyocera@kyocera-tools.ru
Method to change DRC type MagicDrill inserts
How to attach inserts How to detach inserts
Fix drill holder on arbor. For insert ex- Remove dust from insert using air
change, fix arbor on the machine of set blower.
on toolpresetter. Align the wrench properly with the
Remove dust using air blow. insert.
Install insert onto holder. Make sure the wrench is aligned with
(Use gloves to protect your hand from the wrench slots on the insert.
any danger.
Turn the wrench in a counterclockwise
Turn lightly in a clockwise direction. direction.
(Use gloves to protect your hand from
any danger.
Align the wrench properly with the insert.
Make sure the wrench is aligned with Once lock is released, insert can be K
the wrench slots on the insert. turned by fingers.
(Use gloves to protect your hand from
(Improper alignment shown) any danger.
Slot for wrench Remove insert. Drilling
(Use gloves to protect your hand from
Turn the wrench in a slow counterclock- any danger.
wise direction.
Completed.
Coolant
Internal coolant is recommended. In case of external coolant Dry cutting is not recommended.
Cutting depth must be 3xD or less.
kyocera@kyocera-tools.ru K15
www.kyocera-tools.ru
