Kyocera - Основной каталог 2010-2011 ENG
для заказа - kyocera@kyocera-tools.ru [Solid Type]
PSFG-S (Tip Bar) This insert will be switched to HPFG (2-Edge See Page G53).
AT HD
2
8 2
F15
W
2 L2 L1
15 L3
Right-hand Shown 6
Tip-Bar Dimensions Classification of usage P Carbon Steel / Alloy Steel
Description M Stainless Steel
: Continuous / 1st Choice K Cast Iron
: Continuous / 2nd Choice N Non-ferrous Metals
S Titanium Alloy
G
Hard materials (under 40HRC)
H
Hard materials (over 40HRC)
Min. Dimension (mm) TC60 CermetPVD PCD
Cutting Dia. PR630Coated
PR915Carbide
PR930
A W±0.03 r H L1 L2 F T KW10 Carbide
KPD001
PSFG 0810-20S 8 1.0 KPD010
0820-20S 8 2.0 0.05 6.8 6.2 80 25.5 7 3.4 2.0 Grooving
0830-20S 8 3.0
Dimension T shows available grooving depth.
Applicable Sleeve This sleeve is for 1-Edge Tip-Bar. For 2-Edge Tip-Bar, use G53.
Shape
Dimension (mm) Spare Parts
(Previous Screw Wrench
Description Description)
d1 Applicable Tip-Bar
D2
D1D2 d1 d2 H L1 L2
d2
D1H
L2 L1
Std.
PH 0712-60 PH -0712 12 19 6.8 8 11 60 20 HS4X4 LW-2 PSFG 08 -20S
LW-2 PSFG 08 -20S
PH 0716-80 PH -0716 16 22 6.8 Rp1/4 15 80 20 HS4X4
(PS1/4)
(Tip-Bar installation side)
Besides the above Sleeves, Collet Chucks are also available in the market.
Recommended Cutting Conditions
Recommended Insert Grade (Cutting Speed: m/min)
Workpiece Cermet PVD Coated Carbide Carbide
Material
PSFG0810 PSFG0820 PSFG0830 Remarks
TC60
PR630 f (mm/rev)
PR930 0.02 0.04
KW10
0.01 0.02
Carbon Steel / Alloy Steel 60 120 30 100 30 100 0.04 0.06 0.05
0.03 Coolant
Stainless Steel 50 100 30 80 30 80 : 1st Recommendation 0.08
Non-ferrous Metals
300 : 2nd Recommendation
: Std. Item : Check Availability R : Std. Item (R-hand Only) L : Std. Item (L-hand Only) Tip-Bars are sold
in 1 piece boxes.
kyocera@kyocera-tools.ru G57
www.kyocera-tools.ru