Kyocera - Основной каталог 2010-2011 ENG
для заказа - kyocera@kyocera-tools.ru Back Clamp
External Toolholders [CC Insert]
ACLC-F (External / Facing)
F1 2.5 5° 5°
16 *Lock Screw is operated from this direction.
5° h F1 95° H1 B
95° L1
95° 0°
ACLC 1010K-09F
shows above figure.
Right-hand shown L2 H2
Toolholder Dimensions E
Std. Dimension (mm) Standard Corner-R(r) Anchor Pin Spare Parts
Lock Screw Wrench
Description
R L H1=h H2 B L1 L2 F1
ACLC 0810K -06F 82 19 Small Tools
1010K -06F 10 - 10 125 - 10.5 0.2 LPF-11
1010K -09F 10 2 10 125 16 10.0 LPF-13 HSB4X8 FH-2
0.2
1212M -09F 12 - 12 150 - 12.5
LPF-17
1616M -09F 16 - 16 150 - 16.5
Lock Screw : HSB48R for Right-hand Toolholder, and HSB48L for Left-hand Toolholder.
Applicable Inserts Finishing Finishing-Medium Finishing-Medium Low Feed Stainless Steel Cast Iron Non-ferrous Metals Non-ferrous Metals Non-ferrous Metals Hard Materials
B45 B45 B45 B48
Applications B46 B47 B46 B46 C18 C10
Ref. Page GF GK GQ (E / F) -U MQ Without Chipbreaker AH -A3 CBN
Insert
Toolholder
ACLC ...-06F CCGT0602.. CCMT0602.. CCGT0602.. CCGT0602.. - CCGW0602.. - - CCMT0602.. CCMW0602..
ACLC ...-09F CCGT09T3.. CCGW0602..
CCGT09T3.. CCMT09T3.. CCGT09T3.. CCGT09T3.. CCMT09T3.. CCGW09T3.. CCGT09T3.. CCMT09T3.. CCMW09T3..
CCGW09T3..
For recommended cutting conditions, see page E30~E31
Back Clamp Holders
Simple insert replacement,
including with gang-tooling
1. The lock screw can be operated from the back side and The lock screw
allows simple insert replacement on Swiss type automatic can be operated from
lathes (Fig.1)
the back side.
2. Simple insert replacement by slightly turning the wrench.
3. Rigid clamping with anchor pin and lock screw. (Fig.2)
(Fig.1) insert Conventional tool is not
available for gang-tooling.
Anchor Pin
E11
Lock
Screw
(Fig.2)
: Std. Item : Check Availability R : Std. Item (R-hand Only) L : Std. Item (L-hand Only)
kyocera@kyocera-tools.ru
www.kyocera-tools.ru